Does anyone have a good load for deer using the Lyman 287308 bullet in a 7m/m Rolling Block. Shots no farther then 150 yards, small MO whitetails
Printable View
Does anyone have a good load for deer using the Lyman 287308 bullet in a 7m/m Rolling Block. Shots no farther then 150 yards, small MO whitetails
24 - 26 gr H4895 with a Dacron filler. Mine were sized .287, GC and lubed with 2500+. Should run 1600 - 1900 fps.
Don't have any 4895. How about IMR 4198 0r 4227 ?
Buy some? Buy Loading manual? Do not trust internet for reloading amounts is my motto.
Mr Gibson has forgotten more about Remington Rollers then I will ever know. I trust his loading data.Quote:
Originally Posted by Geezer in NH
Not trying to sound disrespectful , but there are many like me that cannot just go out and buy some. We do not have the means and or lucky to have what we have to work with. We live on some small incomes it is just not possible to go buy some.
I just picked up a 6.5 x 55 Swedish mauser and was frustrated at the lack of success with a 140 cast boolit. then I tried 4227 - what a difference!. I was shooting the 7 x 57 with 4350 but accuracy was only so-so. just yesterday I shot some new 7x 57 loads consisting of the rcbs 165 silhouette boolit, sized .285, over 22 grains of imr 4227. now that's my 7x 57 load! hit the 23x36 ram at 500 meters, and was shooting coffee-cup sized groups at 200 meters. works for me!Quote:
Don't have any 4895. How about IMR 4198 0r 4227 ?
I believe a load of IMR 4227 22 gr would give a safe pressure for use in a Rolling Block. I will give it a try
Yes, 21 - 22 gr 4227 should be quite safe in the RB. You might want to start at 19 gr, use a Dacron filler and work up to 23 gr.Quote:
Originally Posted by brstevns
Thanks will see how it goes.Quote:
Originally Posted by Larry Gibson
Maybe not the place but any safe J-word loads for this rifle ?
In my 7x57 Roller I used 34.0 grains of IMR3031 (and 34.0 grains of IMR4064 is just as good) with 175 grain Hornady round nosed bullets loaded WAY out of the case and they shot very well for an old and abused military rifle. (I barely had the bullets seated in the case mouths and they were still well off the throat!)
By the way, if you haven't loaded much for your 7x57 Roller yet I'd suggest neck expanding your brass to make them oversized and then slowly turning your FL sizing die down until the shoulder length is at the correct headspace for your rifle and the brass will JUST chamber with the block fully closed. These old Rollers are a bit notorious for chambers with long headspace and mine definitely is!
brstevns,
FWIW, for RB rifles/rifled muskets, "The Load" is hard to beat at "woods ranges" to 150M. = 13 grains of Red Dot shotgun powder behind most any GCCB for 7mm works fine for WT.
(WT just aren't that hard to kill. = My cousin has killed any number on our farm with a 158 grain LRN in .38SPL.)
yours, tex