-
Mine got here today, but I won't be able to play with it till the end of next week. So it goes...
-
Mine arrived today. Thanks to Jim and the NOE folks.
-
Got mine Wednesday. Thanks for handling this one Jim.
-
Thanks, Jim
Mine safely arrived, the other day, at my new address.
Winelover
-
Mine arrived yesterday. Very good service to New Zealand.
Thanks Swede. It is a thing of beauty! And thanks also to Jim for handling this group buy.
-
-
Mine was here when I finally got home to Colorado. Wonderful machining. I hope to cast with it before June arrives.
-
1 Attachment(s)
Got a few poured!
Had a few hours to dump some lead into mine today...should get to take them for a spin next week!
-
Mine arrived
pretty fast service from the postal outlet. 2 Weeks enroute!
Thanks SciFiJim and Swede and the boys for making this happen!
-
Yahoo.... Got mine... and what a beauty it is...
As has been said many times before; Al & the NOE guys do a fine job of making these moulds... I can see these being as revered as H&G's in the years to come.... It'll almost a shame to pour lead all over it (almost)...
Just need the temperature’s to cool off a little now - having a heat wave in the UK right now... just not used to it....
Might need to go to a personal trainer as well to build my strength up 'cause sure do notice a difference in weight with this brass one after having had a couple of Lee 6 cavs...
Thanks SciFiJim & Al - I am well please and glad I joined this GB.....
-
Cavities different specs
I'm pulling this message because I got the issue sorted out. User error.
-
86LG4T5
Make sure both HP pins are settling down on the brackets the same.
If one pins is taller than the other it could make a difference.
I like to give the hinge pin a little tap, tap, tap as I close the blocks.
Swede Nelson
-
I think you're right. I ran a bunch more today and they were all pretty consistent. Sorry for the trouble!