I need a handle for an older grey Lyman 450. This is the kind where the SizerLuber handle stub is threaded and the Handle has a threaded hole on the end.
I need one because I got a super deal on one without a handle.
Attachment 218093
Printable View
I need a handle for an older grey Lyman 450. This is the kind where the SizerLuber handle stub is threaded and the Handle has a threaded hole on the end.
I need one because I got a super deal on one without a handle.
Attachment 218093
Can it be upgraded to the newer model handle?
Your not going to find a Lyman handle for that.
Someone has replaced the part from a RCBS sizer.
Take a look at this pic.
https://goo.gl/images/urGNFE
Brass lets get together and see if the handle of my RCBS will work if so we can make one or get one tdoor4570
Brass
I think I have the original handle setup to my 450, I upgraded.
Its yours if I can locate it.
PM me if you want it.
Scott
Some years back, I loaned mine to a friend who had never used one. He tried to size some boolits that were cast with the mold held open and quite a bit oversized. Long story short the top angular piece broke. Lyman had an upgrade kit at about $17.98. Well worth it and no problems since, of course only used under my supervision now.
If you can't find an original, let me know. I owe a couple of favors around here anyway. Figure out the TPI and the diameter and I can turn you one.
check the thread size and drill and tap a bar of steel to fit. this is not rocket science.
Believe it or not Lyman said they had part and sent it no charge , guess what they screwed up and sent new model handle . I called and asked what good is this as there is no way this goes on my 450 . Guess it does after saying they would make it right ,they sent upgrade parts (again) no charge !
Attachment 218175Attachment 218176