yesir, those are clean.

loaded my tumbler 5:30 am this morning with 5000 pieces of 9mm brass.(yes ...it is a concrete mixer, modified.)

3 gallons of hot water , a pinch of citric acid and 3 ounces of armor all car wash & wax.
25 pounds of ss pins.....
put my cover over the hole and locked it in place.

turned it on.

forgot about it in the garage churning away for ....oh.....about 11 hours.:shock:

now they are in the brass drier (well 1/2 of them are anyway.)

yesir!
thems is the cleanest i ever did see!

primer pockets like new....insides are just as clean as the outsides.

[smilie=w:

YES, I left some vibrators cleaning brass through out the night
Wow, my how clean
Mike

3 Gallons and 25lbs of pins Mozeppa?

I've left brass overnight in a tumbler and they were pretty darn shiny

surprised you can't see through them.

i can see thru them....no primers!:kidding:

I usually run my Dillon vibrator over night with corncob. I set the timer on my tumbler for 2 hours when using stainless media. Some of the guys using the wet polishing process notice peening around the case mouth if they run too long. Are you seeing any?

A nice addition to your mixer would be a timer. Check them out the next time you are in Home Depot or Lowes!

Leaving them in the acid even though not tumbling still effects them. The SS pins are only cleaning off what the acid/soap loosens. As long as the brass is under water the impact of cases against each other is far worse than with the tiny SS pins. That is the source of any peening seen on the case mouths. In cob or walnut shell, they are cushioned and don't fall unimpeded into each other, thus no peening.

No photos, didn't happen. Internet rulez.