Please put me down for (ONE) 4 cavity mold pb. with HP and Penta pins . thank you . Frank. fivegunner at sbcglobal.net:bigsmyl2:
Printable View
Please put me down for (ONE) 4 cavity mold pb. with HP and Penta pins . thank you . Frank. fivegunner at sbcglobal.net:bigsmyl2:
45,
Mate i definately still want this one, I won't worry about the round pins, but I will get a set of Penta Pins and a set of Blank Pins, email is,
ronandruby At bigpond DoT com
Thanks.
I'm going to have to drop out of this group buy, I picked up a 359640 on the swap forum.
I'm in for one with large HP pins
cthompsonjr at Hotmail dot com
Put me down for one please.
One mold with large hp and blank pins
hickmangroup at gmail DOT com
Put me down for one mold with penta and blank pins.
mswilson1atqdotcom
I'd like one with all pins including blanks
boo-haaa at hotmail dot com
Thanks,
Bushog
I'll have one of these please. One mold, pb, all pins.
brichards hat optics dawt arizona daught edu
Thanks! My first mold was the Mihec H&G 68 clone and I am addicted. This boolit looks like a dream come true.
Please forgive me, but my situation has changed, and have to withdraw from the groupbuys I'm in.
I am #29 on the list.
Do we have any idea on how far off this one is?
I need to change my order a little bit. I want the round hallow point, penta pins. No blank pins.
Garbear.
Guys. I have the 359640 mold with the double crimp groove. They are awesome and you can turn the hollow point pins around so you can cast solid points. The blank pins are not needed.
I have a bunch of Miha's moulds. In fact, I just ordered another off of his website. The blank pins are a must if you do not want to run the risk of damaging your hollow point pins. It will depend on your personal needs/desires in regards to what you cast. If you do more solids than anything else, $16 for the extra pins is not going to break the bank. That is only one trip to McDonalds and I am sure most of us would do better if we would avoid that garbage anyway.
If you are going to cast all HP, then, no, there is no reason to get the blank pins.
Just my 2 cents worth..........
I would like one four cavity mold with the large hp pins and the penta pins.
hillyer56 (att) yahoo.com
Thanks, Dale
I'm going to bail out of this buy.
Sorry for the trouble.
Jeff
Put me down for one (1) 4 cavity mold with large HP and blank pins.
Thanks,
sleeper1428 at charter dot net