Something I learned last weekend, about temp
https://uploads.tapatalk-cdn.com/202...ef0b0f9375.jpg
This was a good thread. Thank you. Beginner here. Same pot, same session, different temperatures. These are the extremes. Most were in between.
I spent my last two casting sessions experimenting with temperature, trying a variety of settings. I learned that turning down the pot temperature helps. Slightly frosted is better than very frosted looking bullets. Not above 6 on the Lee 20# pot dial. And slowing down the casting frequency. Casting with range lead.
Sent from my iPhone using Tapatalk Pro
Something I learned last weekend, about temp
I intentionally ran the temp dial up and down the range. I also slowed down my casting speed to lower the temperature of the mold. I am trying to identify the target temperature. I’m just a beginner.
Sent from my iPhone using Tapatalk Pro