Originally Posted by
Rocky1224
I made a few of these at the 4.6 (Customer provided data on CDVS website) to the overflow capacity with both Hornady 115 grain copper RN and Bob's Lead RN 115 grain. Had an issue with the LRN's and full slide closure and fixed that by a better crimp and attention to detail on COL. Used Glock 26, 19, 17 none of them cycled the slide for both CRN and LRN 115 grn. My Glocks all have non factory Hex barrels. SAME RESULTS as YOURS I cannot use CBI for 115 grain 9mm use. Next is to setup for 124 and 147 after I finish these and my 12 ga shotshells.
For the record, it was low recoil, clean burning, no flash or smoke. I might play with trying to compress this load further and report back with the results.
BOTTOM LINE USING A GLOCK, 115 GR , TOPPING OFF A 9MM CASE THE SLIDE DOES NOT WANT TO CYCLE IN ALL THREE 9MM GLOCKS 26, 19, 17