Originally Posted by
Handloader109
Well, I feel bad. I should have made a comment about this motor when I got it the other day. Yep, just barely above the floor. I am trying to make a t myself. Had a 3mm threaded standoff that I cross drilled and installed a pin. Added loctite to hold it as the motor turns clockwise and will unthread when jam happens. No go, it takes just a bit to break it loose. And I've found my pin is too short and let's collator plate move. Can fix that, but I think I'll have to hit with wire welder, might could booger threads enough, but not confident there.
My other issue is bullets hanging and turning sideways. I'm using mrb's spring but is hanging in printed cone. RN, and three other 9mms I'm playing with. Doesn't matter. Any suggestions guys?
Sent from my KFAUWI using Tapatalk