Printable View
Searched "Star Sizer" for information because I'm still learning about em.
Read a few comments about the handle not staying up and the smashed finger storys from it falling down!
This is my $2 upgrade,,,
Two 6-32 screws, icemaker line for spacers and a spring from the hardware store.
http://i23.photobucket.com/albums/b3...I/100_2306.jpg
Bob.
That is good. It is very similar to mine. I'll post a pic if I have one -- think I took a pic.
here is a pic of my scheme.
Attachment 15442
Two stainless steel cotter pins and an experimentally selected spring. No new holes in the machine. I had to buy a minimum quantity of each so I was going to offer the kits in the swapping and selling section but I would violate the rules by doing so.
I almost did the same thing but the spring didnt seem long enough, looks like you found the right spring. The spring I got was too long so I cut it to fit, but it worked out pretty good the handle will stay up or down.Quote:
Originally Posted by ph4570
Your fix is quicker and easyer and no drilling, good ideal :idea:
Bob.
I monkeyed with several spring combinations. Based on that I determined the spring parameters for a single spring and found "the one" at an on-line supplier.
Oh, it only took me about 10-15 min to install .Quote:
Originally Posted by ph4570
Thats not including the 2 1/2 hours of engineering, trip to the hardware store (I live out in the sticks) and then the tweeks and adjustments?
Still under 3 hours ! [smilie=1:
Bob.
how the heck do you keep your stars looking like that?
mine are all scuffed up and a bit greasy, one of them has mostly black tape for a handle.
i don't think you guy's even use them.
Mine has had much use in the 2 months I have had it. Prior to that I only had a Lyman. Still use the lyman for some boolits.
Mine is new just got it last week but it was sent the wrong dies [smilie=b:Quote:
Originally Posted by runfiverun
Got a pile of boolets ready to size & lube as soon as the dies get here!
Bob.
Bob,
In case you were unaware -- lathesmith, a member of this forum, makes great dies for lower cost and faster delivery than Magma. I have gotten several from him and they are great. He also makes the punches and nuts with allen locks so you can lock the nut on the punch at the proper adjustment.
Thats what I should have done, if I knew then what I know now :roll:Quote:
Originally Posted by ph4570
I will be needing other dies as I get moulds and I will be ordering from him for sure.
Bob.
Great idea, ph4570!
I took two paper clips and a spring that just happened to be the right length and it took me 10 minutes to make it.
:drinks:
Cool. Make sure the paper clips are secure. You would not want them flying out under spring propulsion.Quote:
Originally Posted by olovo
I just use a long twistie, and don't take my hand off the handle when sizing. The twistie goes between handle and compression plunger, to keep the handle up when in storage.