Printable View
I have a Frozone PID from 2013 that has never worked correctly as it does not hold temperature. Does anyone repair these?
UPDATE:
Mike W1 was kind enough to send Frozone instructions.
OBIII looked the unit over, modified it, and returned it with minimal charge. He took care of me as though I was his best customer and it is not even his unit. I am grateful for everyone's help and for this forum!
What brand of controller is it using? A simple test is to set the desired temp a ove room temp. Plug a lamp into the PID. The lamp should be off. Now lower the set temp Below room temp. The lamp should turn on. If it is not doing this, then you may have a problem. If the lamp test works, it has a setting issue.
Ed C
Mypin. It does not hold temp with a probe in the lead pot.
Does the PID bring the lead up to correct temp. and then fail to maintain? How and where is the probe mounted in the lead? Do you have the correct TC probe?
I doubt that it is feasible to repair just replace with new.
It's certainly repairable - highly unlikely the whole thing went to pot, it'll be one part, something wired incorrectly, or a parameter changed inadvertently.Quote:
Originally Posted by wv109323
This PID has never worked, assembly instructions incorrect and Frozone had me move several wires around. Unit sat for 2 years until needed again and it will take time to go over the unit connection by connection before parameters are set. Mike W1 was kind enough to sent diagrams and start-up procedures so a baseline can be established. A little patience and lots of persistence will make this happen. Thanks to all for your input and advise, it is appreciated.
Updated first post
I have dealt with OBIII before, good guy!
Did OBIII happen to mention what kind of a problem he found? Always nice to have troubleshooting ideas.
My programming skills are weak. One of the parameters reset to default after my failed attempts to set it. I had no clue, and if a hammer won't fix it, there is an electrical problem…..
One of the differences in setting both the Mypin and a Rex is that they require you to press SET after you have the value where you want it. The Auber I have just needs to be shifted to the next parameter and sets itself.
I find it useful to record the factory settings (and their rotational order) as well as which ones I change and the setting I change it to. Most of them don't need to be changed from factory default.