1 Attachment(s)
How to remove a snapped off screw
Have a old 32 walther that has a snapped off hand grip screw.
I tried to grab on it with some thin wire cutter pliars but could not get enough grip to turn it.
Can't get behind it either.
So what would be the best way to remove it and keep the same screw/thread as the other side?
Attachment 298206
How to remove a snapped off screw
Some things I might try:
Cutting a slot in the stub if you get to it.
Solder a stub to it (or just try to heat/cool cycle it with a soldering gun)
A very sharp punch on the face and tap it ccw?
Perhaps a left hand drill bit smaller than the screw?
Last resort would be to drill the center with a much smaller bit and a use tiny easy-out. Breaking an easy out in the screw will make extraction 10x harder