Can this mold be recovered?
Bought a $10 burner to heat my mold but after reading the temp with a laser it could only reach about 200F. This lead to a lot of wacking on the side of the mold to release the bullets and it got messy from the inside with bits of lead clinging inside and on top of the below the sprue plate.
Is the first option to heat up the mold and scrape the lead with a wooden pick and what can i find at my local CVS or hardware store to clean the mold from any residue left over?
http://i63.tinypic.com/9tz8sh.jpg http://i66.tinypic.com/14ccv0n.jpg