Printable View
I own a B & M powder measure that does not return after moving lever to charge the cartridge. I need to manually move it back to the original starting position. What is wrong and can it be repaired? It measures accurately but is a pain to use and I don't want to discard it.
Any help is appreciated! Thanks
Is your return spring broken?
Attachment 302599
I have seen a couple at shows that had the spring removed. When asked abut it I was told it made them easier to operate and allowed lighter clamping pressure.
There is an internal return spring, IIRC. I felt like it was too hard to fight with so I took all the return springs out of one and just remembered to move the handle back manually (most of the time!) :roll:
Froggie
Where is this internal spring located? I know it is probably behind one of the many screws....but which one?
If you look at post-2, it is to the left of the aluminum casting on the left side of the measure.Quote:
Originally Posted by buggybuilder
In this photo, you are looking at the measure from the back.
Attachment 302620
It’s actually only partly internal, as shown in post #2 above. I tried a weaker one, then in disgust left it out altogether. I don’t recommend, unless it’s being used a lot and you develop the habit of returning the fQuote:
Originally Posted by buggybuilder
Lever each time. Sorry for leaving the wrong impression.
Froggie
Mine was broken when I bought my measure too. I had a box of assorted springs that I have collected over the years. I tried several different springs until I found the one that operated the lever the way I wanted it to.
Good luck with yours.