Lee PrecisionWidenersRotoMetals2ADvertise here
Inline FabricationTitan ReloadingMidSouth Shooters SupplyRepackbox

  • n.h.schmidt's Avatar
    06-29-2019, 05:50 PM
    You don't want to shoot these jacketed WC bullets below mid power. Low power jacketed bullets can stick in the barrel do to high friction and the barrel gap will bleed off the gas. Plain lead is ok in low power though. Don't want to rain on the fun...
    22 replies | 1123 view(s)
  • n.h.schmidt's Avatar
    06-25-2019, 08:03 AM
    The lube dosn't hardly stick to the bullet base at all. They are usually good to go. You don't get as much lube going down as you would think. I mostly had problems when lubing bullets that needed little or no sizing and had little friction to hold...
    9 replies | 398 view(s)
  • n.h.schmidt's Avatar
    06-24-2019, 06:05 PM
    I have drilled the push out rod through. A 3/16" drill would do. I also used a center drill on the top so only a small ring of steel touches the bullet base. . Any excess lube will go down the rod and out the bottom. I seen this done in a NRA cast...
    9 replies | 398 view(s)
No More Results
About n.h.schmidt

Basic Information

Age
66
About n.h.schmidt
Biography:
Retired Phone worker .Been a shooter for 35 years
Location:
eastern Iowa
Interests:
shooting cast bullets and RC boat raceing

Statistics


Total Posts
Total Posts
379
Posts Per Day
0.10
General Information
Last Activity
Yesterday 04:03 PM
Join Date
03-21-2009
Referrals
0
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check