WidenersTitan ReloadingADvertise hereRepackbox
RotoMetals2Lee PrecisionMidSouth Shooters SupplyInline Fabrication

Tab Content
  • No_1's Avatar
    Today, 12:53 PM
    No_1 replied to a thread online handle/username in Our Town
    I also like #3ís and I have all but the 30-40 Krag which I did have until I sold it to Typecaster. One day I will get another. My favorite #1 (at the moment) is a HP commemorative chambered in 357 Mag. My favorite #3 (at the moment) is one...
    141 replies | 5013 view(s)
  • No_1's Avatar
    Yesterday, 05:05 PM
    No_1 replied to a thread online handle/username in Our Town
    Ruger single shot rifles.
    141 replies | 5013 view(s)
  • Lloyd Smale's Avatar
    Yesterday, 01:36 PM
    4895 has always been THE powder for 308 accuracy with jacketed bullets.
    10 replies | 221 view(s)
  • Lloyd Smale's Avatar
    Yesterday, 08:57 AM
    I run Bilstein 5100s on mine and duel steering stabilizer shocks. It helps but its still a short wheel base jeep. Mines a 2015 and like was said if you think your 10 is bad try the same road with a tj or worse yet a yj. Best ride with mine is with...
    20 replies | 477 view(s)
  • Lloyd Smale's Avatar
    Yesterday, 07:53 AM
    Lloyd Smale replied to a thread what size truck in Our Town
    you were right when you said a gas motor would pull it. Some forget were talking v8s with 400 hp and over 400 ftlbs of torque. NOT the 200 hp slugs we had a decade ago. Put a set of 410s in the rear and you can pull what a semi could in the 60s and...
    49 replies | 1311 view(s)
  • Lloyd Smale's Avatar
    Yesterday, 07:41 AM
    Lloyd Smale replied to a thread what size truck in Our Town
    Now heres an honest man. No chest thumping or trying to fight a loosing battle justifying it.
    49 replies | 1311 view(s)
  • Lloyd Smale's Avatar
    Yesterday, 07:38 AM
    wish I had an obscene amount of type lead. Then I wouldn't worry about it either. I don't agree on ww cutting the mustard for 1900 fps loads. At least not if you want the best accuracy. Ive been fooling a lot with the black out this summer and loads...
    63 replies | 1799 view(s)
  • Lloyd Smale's Avatar
    07-15-2019, 07:58 AM
    heck my pot is on a bench that's 2 or 3 feet about my bucket and a foot and half back from the edge. Youd probably have to drop a 5lb weight in it to get water to fly that far.
    63 replies | 1799 view(s)
  • Lloyd Smale's Avatar
    07-15-2019, 07:53 AM
    Lloyd Smale replied to a thread what size truck in Our Town
    you could probably knock 10k off that question and still hear a pin drop.
    49 replies | 1311 view(s)
  • Lloyd Smale's Avatar
    07-15-2019, 07:52 AM
    Lloyd Smale replied to a thread Black guns in Factory Rifles
    probably true. Its probably why they charge us twice what a dmps or bushmaster that's just as good costs. They think were sappy enough to believe that the government picked them because there better quality. Not because at the time there were few...
    54 replies | 3056 view(s)
  • No_1's Avatar
    07-14-2019, 06:38 PM
    Talk with Hatch from ---> Hatch Automation <---. I believe his is set up uses pneumatics controlled by a PLC.
    13 replies | 251 view(s)
  • Lloyd Smale's Avatar
    07-14-2019, 03:32 PM
    Lloyd Smale replied to a thread Black guns in Factory Rifles
    actually mil spec parts are parts that the government (both those that know and those that don't and those who count pennys) decide was the minimum standard for procurement. They put out the spec sheet and then hire someone to build them. Price...
    54 replies | 3056 view(s)
  • Lloyd Smale's Avatar
    07-14-2019, 01:09 PM
    Lloyd Smale replied to a thread what size truck in Our Town
    so in law is on 300k on his. But hes put a fuel pump or whatever you all it in them. Two transmitions (autos) rebuilt the front end totally 3 times. Front pumkin blew the gears out and one turbo. Granted it has 300 k on it and he uses it as a truck...
    49 replies | 1311 view(s)
  • Lloyd Smale's Avatar
    07-14-2019, 08:47 AM
    Lloyd Smale replied to a thread ar10??? Pc??? in Factory Rifles
    thanks for the heads up on that sight. Lots of good info there.
    24 replies | 952 view(s)
  • Lloyd Smale's Avatar
    07-14-2019, 08:28 AM
    Lloyd Smale replied to a thread ar10??? Pc??? in Factory Rifles
    bubba I fought over pressure in my dpms ar10 back about 15 years ago. Ars weren't the craze then and there wasn't much help with problems. I eventually was told to put an adjustable gas block on it and paid GOOD money for one back then and it cure...
    24 replies | 952 view(s)
  • Lloyd Smale's Avatar
    07-14-2019, 08:03 AM
    I size after I coat and size all my 10s and 40s to 401. Glocks, smiths, and sigs. Now im not going to tell you that's absolutely the best size for accuracy because I quit benching black guns years ago. I might sit and shoot 10 shots out of a new gun...
    25 replies | 1309 view(s)
  • Lloyd Smale's Avatar
    07-14-2019, 07:53 AM
    1 a cast bullet dropped into a bucket of water on the floor doesn't react like dumping water in your pot. Ive been doing it for 30 years and never had the tinsel fairy visit because of water dropping. Now I wont say shes never visited though, just...
    63 replies | 1799 view(s)
  • Lloyd Smale's Avatar
    07-14-2019, 07:34 AM
    I wont argue using the alloy that gives the hardness you want. Other then cost. Linotype is tough to find anymore and expensive. Back in the day when I could get it about free and had hundreds of lbs of it I didnt water drop either. But when I have...
    63 replies | 1799 view(s)
  • Lloyd Smale's Avatar
    07-14-2019, 07:28 AM
    power air fryer xl. Wife bought it on line. Its about the best thing going for frozen fries. MUCH better then in the oven. Not quite as good as home made but good enough that you wont want to do home made and clean the mess up after trying them. Ive...
    3 replies | 166 view(s)
More Activity
About JeffinNZ

Basic Information

Date of Birth
September 24, 1969 (49)
About JeffinNZ
Location:
Christchurch, New Zealand
Interests:
Things that go bang and relocate lead.
Occupation:
Freight forwarder

Signature


Thermal underwear style guru.
"Exclusive international distributor of Jeff Brown Hunt Club clothing."
Supplier to the rich(?) and infamous.

Cheers from New Zealand

Jeff.

Floyd Files.

Statistics


Total Posts
Total Posts
5,818
Posts Per Day
1.15
Albums
Total Albums
2
Total Photos
24
General Information
Last Activity
07-09-2019 03:09 AM
Join Date
09-06-2005
Referrals
2
Home Page
http://www.beavergrease.co.nz

9 Friends

  1. Bigjohn Bigjohn is offline

    Moderator Emeritus

    Bigjohn
  2. bruce drake bruce drake is offline

    Boolit Master

    bruce drake
  3. Buffalo Barbie Buffalo Barbie is offline

    Boolit Mold

    Buffalo Barbie
  4. carpetman carpetman is offline

    Boolit Master

    carpetman
  5. InNZ4aYear InNZ4aYear is offline

    Boolit Mold

    • Send a message via AIM to InNZ4aYear
    InNZ4aYear
  6. Jim Jim is offline

    Boolit Grand Master

    Jim
  7. Lloyd Smale Lloyd Smale is offline

    Boolit Grand Master

    Lloyd Smale
  8. no34570 no34570 is offline

    Boolit Master

    no34570
  9. No_1 No_1 is online now

    Cast Boolits Owner

    No_1
Showing Friends 1 to 9 of 9
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check