RotoMetals2StainLess Steel MediaADvertise hereInline Fabrication
MidSouth Shooters SupplyGraf & SonsLee PrecisionTitan Reloading

Tab Content
  • hiram's Avatar
    02-21-2018, 06:10 PM
    Is there a chart somewhere that shows recommended front apertures for various bulls eyes at various ranges? There use to be an excellent chart by "Fuzzy Limey" but I can't find it. Thanks
    9 replies | 165 view(s)
  • hiram's Avatar
    01-28-2018, 04:29 PM
    I use 1/4" socket on ratchet handle. The socket is good because it has more bearing surface on the hex stem than the lyman product. Also, the longer handle = more leverage.
    21 replies | 864 view(s)
  • hiram's Avatar
    01-28-2018, 04:13 PM
    I have both. Whereas the ultrasonic cleans the grime, grit, or other dirt off the case, it does not polish. The cases are still dull and 'look' dirty, but they are clean. The thumblers tumbler leaves my 45-70 cases clean enough that when you...
    32 replies | 1160 view(s)
No More Results
About hiram

Basic Information

Date of Birth
November 16, 1949 (68)
About hiram
recently into BPCR. Reloading and casting for quite a while.
Boynton Bch., FL
shooting, fishing
high school teacher--retired


Rich or poor, it's good to have money.


This Page
Instant Messaging

Send an Instant Message to hiram Using...


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
02-21-2018 06:10 PM
Join Date
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check