RepackboxInline FabricationWidenersRotoMetals2
Titan ReloadingGraf & SonsMidSouth Shooters SupplyLee Precision

Tab Content
  • Anuccite's Avatar
    03-14-2019, 07:20 AM
    What size screws do i need to source? I think I found among the thread I need M5-.8 x25 MM for the MBF Motor..... Any idea on what other size hardware i need to source? found this on amazon.... Are these too small for the project?...
    648 replies | 61223 view(s)
  • Anuccite's Avatar
    03-12-2019, 05:01 PM
    Yea, I have some issues with it and coated bullets.... so this may be the time to switch over
    648 replies | 61223 view(s)
  • Anuccite's Avatar
    03-12-2019, 04:22 PM
    Just pulled the Trigger on an Ender 3x with Glass bed........ Can't wait to get started on my bullet feeder.... Will be using it with the Horady LnL AP . I have the hornady bullet feeder die already, hoping to make that work.
    648 replies | 61223 view(s)
No More Results
About Anuccite

Basic Information

Statistics


Total Posts
Total Posts
3
Posts Per Day
0.31
General Information
Last Activity
03-18-2019 06:35 AM
Join Date
03-11-2019
Referrals
0
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check