Inline FabricationMidSouth Shooters SupplyTitan ReloadingRotoMetals2
WidenersADvertise hereLee PrecisionRepackbox

  • clodhopper's Avatar
    05-24-2020, 11:07 PM
    This question comes up so often. Brass is a little harder than copper, but compared to steel, brass is soft. Hot copper is sticky, but the addition of zinc makes brass comparatively slick. Most bullets are jacketed with gilding metal, which...
    13 replies | 437 view(s)
  • shell70634's Avatar
    05-19-2020, 07:35 PM
    Before posting any pics I open them with the Paint program on my computer and resize them. Most from my phone are 4000 x 3000 or so pixels. I resize to 1000 or less, then crop, then save. They load up much quicker for me. I'm not computer...
    3 replies | 91 view(s)
  • clodhopper's Avatar
    05-16-2020, 06:23 PM
    Good looking bullets.
    13 replies | 437 view(s)
  • shell70634's Avatar
    05-16-2020, 01:03 PM
    My daughter had 20 or so stolen in east Texas about 5 years ago. They've gotten 5 or 6 back. One from Ohio. The SO gave them back within a couple days of receiving them. Still looking for the rest.
    68 replies | 1754 view(s)
  • clodhopper's Avatar
    05-14-2020, 11:47 PM
    clodhopper replied to a thread Joining an airgun forum in AirGuns
    Bob Strene is on many forums, even castboolits.gunloads.com
    12 replies | 1513 view(s)
  • clodhopper's Avatar
    05-13-2020, 03:50 PM
    I was using a lyman big dipper until the heating coil burned out. Strongly considering Turning some scrap aluminum to fit tight, and fill the bottom half of the pot.
    21 replies | 661 view(s)
  • shell70634's Avatar
    05-11-2020, 04:19 PM
    I'll take it. PM follows Shelly
    1 replies | 646 view(s)
  • clodhopper's Avatar
    05-03-2020, 11:03 PM
    clodhopper replied to a thread Core bonding in Swaging
    I've had failure to bond using flux and heating the bullets in an oven. 100% success use the same corbin flux, and heating the bullets quickly with a torch.
    18 replies | 1388 view(s)
  • clodhopper's Avatar
    05-03-2020, 12:19 PM
    clodhopper replied to a thread Matador in AirGuns
    Too busy looking for the next one to do photography.
    29 replies | 4689 view(s)
  • clodhopper's Avatar
    05-02-2020, 08:08 AM
    clodhopper replied to a thread Matador in AirGuns
    Guilty here! found the last two replacement batteries in junque drawer. Already ordered the old school gage. Would rather have a needle gage anyway. Faster to get a reading, no little LED light shining at the target, no battery aggravation. Those...
    29 replies | 4689 view(s)
  • clodhopper's Avatar
    05-01-2020, 11:46 PM
    clodhopper replied to a thread Matador in AirGuns
    Ok the Matador has a problem. It's the pressure gage. An electronic pressure gage comes with the rifle. The thing has a microprocessor and can give you information such as how much pressure in the tank, how many shots are left, how much pressure...
    29 replies | 4689 view(s)
  • clodhopper's Avatar
    05-01-2020, 11:29 PM
    clodhopper replied to a thread Fx in AirGuns
    Randy, Your question has me wondering what information you are looking for. Did I miss a bit of fun being poked my way? I think not. Reading your posts over several years leaves me with the impression that a post by you has valid information....
    7 replies | 396 view(s)
  • shell70634's Avatar
    05-01-2020, 09:33 PM
    RJ Renner http://www.rjrenner.com/
    6 replies | 395 view(s)
  • clodhopper's Avatar
    05-01-2020, 10:54 AM
    clodhopper replied to a thread Fx in AirGuns
    This used to be a quiet little cow town when I moved here 42 years ago. Now it's a very fast growing, sprawling, suburbia. Places I used to shoot a .243 are surrounded by houses. Air guns do not carry as far. Needing to be able to make hits to...
    7 replies | 396 view(s)
  • clodhopper's Avatar
    05-01-2020, 08:18 AM
    clodhopper replied to a thread Fx in AirGuns
    He chose the .22. Out in this part of the country we have ground squirrels. They are in full bloom right now. There are several different species, including prairie dog. In this part of Montana they are all gophers. Lots of different names in...
    7 replies | 396 view(s)
  • clodhopper's Avatar
    04-30-2020, 11:12 PM
    clodhopper started a thread Fx in AirGuns
    Slithered out of bed at 2:30 AM this morning, Met a friend and drove 450 miles to Utah Airguns to see/fondle/shoot the FX impact. Nice rifle, shoots well, and the bottle feels surprisingly nice in the support hand while shooting standing. My...
    7 replies | 396 view(s)
  • clodhopper's Avatar
    04-29-2020, 10:50 PM
    It might be pretty shocking how quickly he could get one out.
    6 replies | 1719 view(s)
  • shell70634's Avatar
    04-29-2020, 06:59 PM
    Thank you for all the advice and opinions. I have many magnum guns to chose from if I want power. I was wondering where the Model 25 fit in the reloading manuals range. I know it will handle more than an old Colt SA and less than a modern Ruger...
    22 replies | 1542 view(s)
  • shell70634's Avatar
    04-29-2020, 12:37 PM
    I'll take #3, the 45 acp kit. PM to follow. Shelly
    2 replies | 132 view(s)
No More Results
About clodhopper

Basic Information

Date of Birth
December 29, 1955 (64)
About clodhopper
Biography:
shooting enthusiast
Location:
Bozoland Mt.
Interests:
Shoot steel shoot paper shoot gophers tip over a deer every now and then
Occupation:
make log homes

Signature


To lazy to chase arrows.
Clodhopper

Statistics


Total Posts
Total Posts
1,575
Posts Per Day
0.35
General Information
Last Activity
Today 07:32 AM
Join Date
02-28-2008
Referrals
3

8 Friends

  1. *Paladin* *Paladin* is offline

    Boolit Buddy

    *Paladin*
  2. marteeson marteeson is offline

    Boolit Mold

    marteeson
  3. Mtman314 Mtman314 is offline

    Boolit Buddy

    Mtman314
  4. muzzlebuster muzzlebuster is offline

    Boolit Mold

    muzzlebuster
  5. rjathon rjathon is offline

    Boolit Buddy

    rjathon
  6. shadowcaster shadowcaster is offline

    Boolit Buddy

    shadowcaster
  7. shell70634 shell70634 is offline

    Boolit Buddy

    shell70634
  8. wildwes wildwes is offline

    Boolit Bub

    wildwes
Showing Friends 1 to 8 of 8
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check