Titan ReloadingInline FabricationRepackboxMidSouth Shooters Supply
Lee PrecisionGraf & SonsWidenersRotoMetals2

  • Gewehr-Guy's Avatar
    Yesterday, 02:13 PM
    RJM52,very good post.
    29 replies | 348 view(s)
  • Gewehr-Guy's Avatar
    Yesterday, 02:09 PM
    After examining a Jennings .22 and a Davis .380, they both have side and vertical play in the slides, and with enough wear could cause off center strikes. When you remove the takedown plunger at the rear of the slide, see if the groove ,(where it...
    16 replies | 237 view(s)
  • Gewehr-Guy's Avatar
    03-21-2019, 01:25 PM
    You might find a little S&W Hand Ejector in .32 Long, they have a nice smooth action and you could load them down for practice till she got used to more recoil. Even with a 4 inch barrel they are pretty small. I also have a Charter in .22, neat...
    29 replies | 348 view(s)
  • Gewehr-Guy's Avatar
    03-19-2019, 04:15 PM
    Were the later spitzer bullet loads meant to be used in the 91, as I always heard you had to keep the earlier Mauser rifles around 45,000 psi ?
    9 replies | 278 view(s)
  • Gewehr-Guy's Avatar
    03-17-2019, 10:57 PM
    If you were closer I'd lend you my Milwaukee magnetic drill to bore the holes for presses, you are gonna get tired with a hand drill.Thats also a great table for a barrel vise.
    26 replies | 634 view(s)
  • Gewehr-Guy's Avatar
    03-15-2019, 08:21 PM
    It looks like Fedarm has .217 primers,but for the 7.62x39, might be a bit thinner and weaker than the ones for the heavier calibers. Might work great for lighter cast loads,so I might try to get some, to use with some 8mm and 7.5x55 brass. They...
    13 replies | 699 view(s)
  • Gewehr-Guy's Avatar
    03-15-2019, 01:36 PM
    I watched a couple of videos of siberian trappers in the tiaga, one was concerned about the bears not in hibernation yet, and him with no slugs for his shotgun, so he carved a hole in a piece of firewood, and melted down a bit of lead he scrounged...
    23 replies | 647 view(s)
  • Gewehr-Guy's Avatar
    03-14-2019, 07:53 AM
    I think I could use a box. will send PM, Jim
    5 replies | 453 view(s)
  • Gewehr-Guy's Avatar
    03-11-2019, 09:37 PM
    Gewehr-Guy replied to a thread Lyman 311644? in Cast Boolits
    I have that mould and have used it in a 1903a3, and it shot well, and Iv'e loaded a few with different powders this winter for further testing, but this weather just won't give us a break. I think it would be an excellent bullet for a krag, with a...
    4 replies | 138 view(s)
  • Gewehr-Guy's Avatar
    03-11-2019, 01:54 PM
    Didn't John Browning make his first automatic out of a 73 Winchester ? That flapper lever contraption on the muzzle kind of spoiled the fine lines of the original rifle though!!! An upscaled 1890 Win design, with the upper end of the magazine tube...
    27 replies | 784 view(s)
  • Gewehr-Guy's Avatar
    03-11-2019, 01:30 PM
    Gewehr-Guy replied to a thread Canadian Bacon in Cookin' Recipe's
    It's been a few years ago, but I helped a friend do a couple of hogs, and we bought a few loins to cure while we did the hams. He used the Morton's brand sugar cure, and we used the dry rub method, just covering the surface of the loin and rubbing...
    4 replies | 171 view(s)
  • Gewehr-Guy's Avatar
    03-05-2019, 03:16 PM
    Gewehr-Guy replied to a thread Bounty hunter in Our Town
    I would like to know if this program has a budget cap, or will be a year to year program dependent upon the advice of the Game Dept. or state lawmakers. I don't think they realize how many tails they are going to receive, my guess is that people...
    20 replies | 738 view(s)
  • Gewehr-Guy's Avatar
    03-04-2019, 10:24 PM
    Gewehr-Guy replied to a thread Bounty hunter in Our Town
    I guess I should have specified, they don't want the critter, just the tail :-P , and only taken between April 1 and August 31. Not sure why they don't want the coyotes?
    20 replies | 738 view(s)
  • Gewehr-Guy's Avatar
    03-04-2019, 09:17 PM
    Gewehr-Guy started a thread Bounty hunter in Our Town
    The state of South Dakota just introduced a new plan to boost the pheasant numbers by offering a $10 bounty on raccoons,skunks,possoms,badgers, and red fox. They will be distributing 16,500 live traps free of charge to the first 5500 people that...
    20 replies | 738 view(s)
  • Gewehr-Guy's Avatar
    03-04-2019, 08:44 AM
    Kev18, winchester made offset adapters to offset their A5 scopes for use on levers and clip loading bolt rifles, but I can imagine they were not popular, and would be very hard to find. I lucked onto a set mounted on ,of all things, a Savage bolt...
    22 replies | 3980 view(s)
  • Gewehr-Guy's Avatar
    03-03-2019, 07:14 AM
    For cleaning I've been using either Kroil or Eds Red, then a patch saturated with Bens Liquid Lube or thinned LLA.
    25 replies | 866 view(s)
  • Gewehr-Guy's Avatar
    03-01-2019, 08:07 AM
    Gewehr-Guy replied to a thread CWD and You in Cookin' Recipe's
    Now the severe winter has driven the deer into large herds,and that usually doesn't contribute to the overall deer health. My neighbor has about 250+ around his farm, and about 40 of them are in my feed every night. Most of the ones hanging around...
    24 replies | 1076 view(s)
  • Gewehr-Guy's Avatar
    02-27-2019, 07:41 AM
    Does the charge cup have any markings on the handle, or the bottom? I still load with my 30 US tool,great fun!
    10 replies | 541 view(s)
  • Gewehr-Guy's Avatar
    02-24-2019, 08:36 AM
    Petander,your picture of AO sure looks pink,not the light green color of my Vectan AO . And those big green flakes slide through a powder funnel better than the Alliant disc powders, IMHO . If cabin fever gets any worse and winter lasts into July, I...
    37 replies | 1657 view(s)
No More Results
About Gewehr-Guy

Basic Information

Statistics


Total Posts
Total Posts
399
Posts Per Day
0.48
General Information
Last Activity
Yesterday 09:45 PM
Join Date
12-14-2016
Referrals
0
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check