Lee PrecisionInline FabricationGraf & SonsTitan Reloading
StainLess Steel MediaADvertise hereRotoMetals2MidSouth Shooters Supply

Tab Content
  • vzerone's Avatar
    Yesterday, 11:43 PM
    They aren't pinned!!!
    9 replies | 238 view(s)
  • vzerone's Avatar
    Yesterday, 04:52 PM
    Why would a five groove be any different? They drill the hole, ream it and hone it and that's your bore. So it would have the same bore as 4/6/etc groove barrels. Micro Groove is slightly different. All you need is a V block to use with you mic...
    9 replies | 238 view(s)
  • vzerone's Avatar
    Yesterday, 09:26 AM
    I have to agree with you Lloyd. Razor Dobbs killed two cape buffaloes with a 5 inch barreled Sig 1911 in 10mm. He had through and through penetration on both of them and was using, I believe, Sledgehammer hard cast. I watched it on video and can...
    69 replies | 1588 view(s)
  • vzerone's Avatar
    04-16-2018, 07:13 PM
    Huh, I was of the belief that the wind pushes the whole bullet to the direction it's blowing rather then turning the nose to that direction. If it turned the nose Wow could you imagine how far off target the bullet would be then? Think about it,...
    30 replies | 756 view(s)
  • vzerone's Avatar
    04-16-2018, 12:25 PM
    Don'tcha know you are suppose to bring a plum bob or level with ya when setting up a target?? :kidding::kidding::kidding:
    30 replies | 756 view(s)
  • vzerone's Avatar
    04-16-2018, 09:56 AM
    Waco you're getting there, but a few things concern me. Was your target backer board plumed vertically? I ask because a good number of your bullet holes look like they hit at an angle. It's either that or your bullets were yawing/not stabilized. ...
    30 replies | 756 view(s)
No More Results
About Moleman-

Basic Information

About Moleman-
Location:
SW Michigan next to a winter wheat field

Statistics


Total Posts
Total Posts
465
Posts Per Day
0.73
General Information
Last Activity
Today 12:27 AM
Join Date
07-24-2016
Referrals
0

1 Friend

  1. vzerone vzerone is offline

    Boolit Master

    vzerone
Showing Friends 1 to 1 of 1
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check