RepackboxInline FabricationGraf & SonsTitan Reloading
WidenersMidSouth Shooters SupplyLee PrecisionRotoMetals2

Tab Content
  • Moleman-'s Avatar
    03-20-2019, 08:28 AM
    There's pretty good video "evidence" that a 30 hawkens won't effectively kill a deer. Quite frankly I'm shocked that this vital evidence hasn't been brought up, but none the less you should watch Jeremiah Johnson...again. His 30 hawkins couldn't...
    64 replies | 3538 view(s)
  • Moleman-'s Avatar
    03-19-2019, 08:19 AM
    Moleman- replied to a thread What ? Front sight in Our Town
    Looks like an enfield #4 front sight.
    2 replies | 210 view(s)
  • Moleman-'s Avatar
    03-07-2019, 08:20 AM
    What did the water capacity turn out to be? It seems like from the load data released by Win that there would still be some gains for a hand loader.
    124 replies | 5136 view(s)
  • Moleman-'s Avatar
    03-05-2019, 09:09 PM
    That's pretty close. If you figure if there's no free lunch, you can adjust the case water capacity to 33.0gr so the FPS matches the chrony which bumps your pressure up to about 42,126 psi. The bolt thrust is less than a 12ga and you've put a...
    54 replies | 2171 view(s)
  • Moleman-'s Avatar
    03-04-2019, 06:33 PM
    Nice job on the conversion! I've used half a dozen of the timberwolf blanks for 357 and 9mm and have been happy with them. Think I've still got 2-3 9mm that were made with them.
    65 replies | 2806 view(s)
  • Moleman-'s Avatar
    03-04-2019, 05:21 PM
    KLR, are you using the same 2.0" col or 2.1"? I ran it both ways. 2.0" col, 360-230fn NOE, 16.5gr Lilgun 18" barrel....39,116 psi, 1640 fps. 2.1" col """"""""""""""""""""""""""""""""""""""""""""".....30,293 psi, 1579 fps. Ran the same...
    54 replies | 2171 view(s)
  • Moleman-'s Avatar
    02-24-2019, 07:57 PM
    Moleman- replied to a thread Chicago 18 Volt Battery in Our Town
    Rebuild it yourself. Take your battery apart and look at the individual batteries. Likely they're sub-c sized batteries. There may or may not be a resister somewhere in the charging line coming in. I rebuilt the batteries in my milwaukee 18v a...
    19 replies | 734 view(s)
  • Moleman-'s Avatar
    02-24-2019, 04:04 PM
    We're getting the same storm. Has to be pretty windy for snow to blow into my barn from under the overhang, but it'd currently snowing on my Sheldon lathe :( Got a tarp on it now and the diesel generator on the charger waiting for the power to go...
    54 replies | 2171 view(s)
  • Moleman-'s Avatar
    02-24-2019, 01:59 PM
    I saw this pic leaked online. Looks like they went with someone elses design this time :-D
    54 replies | 2171 view(s)
  • Moleman-'s Avatar
    02-24-2019, 12:36 AM
    I've also been looking at the MP-359 220gr WNFP HP GC, or perhaps having it made a little heavier near 260gr. For my rimless the Lyman 204gr RN looks good too. I need to start casting again before it warms up and I've got nothing to shoot.
    54 replies | 2171 view(s)
  • Moleman-'s Avatar
    02-23-2019, 09:44 PM
    If that's the NOE 360-230FN then QL is pretty close at 1070 for the guess from COL 2.0, 6.0gr titegroup. 12.0gr LilGun guess is 1226 fps, 13.0gr is 1325 fps, 15.5gr is 1558 fps at 32Kpsi....ISH.
    54 replies | 2171 view(s)
  • Moleman-'s Avatar
    02-23-2019, 11:48 AM
    Yes, and as I've said it's likely way over the top and most guys don't bother. The cases I've tried have worked fine with the wrinkle and it mostly disappears after a few firings. I've switched to mainly forming cases from the starline 223 basic...
    10 replies | 984 view(s)
  • Moleman-'s Avatar
    02-22-2019, 10:49 PM
    I haven't shot any cast ones lighter than the 208gr shown in post #49 and lately have mostly been shooting the 228gr NOE shown in the same post. Speeds 1700-1900's with gas checks and Lyman alox #2857277 stick lube. Usually hovering around 1"-1.5"...
    81 replies | 15783 view(s)
No More Results
About Moleman-

Basic Information

About Moleman-
SW Michigan next to a winter wheat field


350 Legend, imitation is the highest form of flattery. Aww, Thanks Winchester!


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Today 03:25 AM
Join Date

1 Friend

  1. vzerone vzerone is offline


Showing Friends 1 to 1 of 1
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check