RotoMetals2Titan ReloadingADvertise hereWideners
Lee PrecisionInline FabricationRepackbox

Tab Content
  • Hamish's Avatar
    Today, 03:12 PM
    Hamish replied to a thread 30 Bobcat in Case Forming / Re-forming
    Anything between .30 Makarov/Mauser length and full length Max. I know fellow's shooting all kinds of different length, rimmed and rimless, single shot, bolt, AR. Little thirties are more for funner.
    19 replies | 2436 view(s)
  • Walks's Avatar
    Today, 01:07 PM
    Walks replied to a thread Air cool vs water cool in Cast Boolits
    Never had ANY Problems water dropping bullets. No dents, I water drop into a 5gal. bucket. With 4 gal. of water, I put a wet towel over the top of the bucket with a 4" hole cut into the center. The towel contacts the water. Bullets hit the wet towel...
    47 replies | 845 view(s)
  • Walks's Avatar
    Today, 12:33 PM
    I grew up on it. My Dad loaded it in just about every cast bullet load with the exception of His Bullseye Competition Loads and Hot .357Mag & .44Mag loads. And that is a lot of .380, .38Spl, .44Spl , .45Colt, .45ACP Hardball. And a bunch of rifle...
    52 replies | 1770 view(s)
  • Outpost75's Avatar
    Today, 12:13 PM
    Accurate 31-120TG is designed for the M1 carbine:
    2 replies | 84 view(s)
  • Hamish's Avatar
    Today, 11:11 AM
    Hamish replied to a thread 30 Bobcat in Case Forming / Re-forming
    Tom, By any chance, do you have a set of 300 Blackout dies to do a comparison? Would be quite interested to see the dimensional differences between a .30 Bobcat and a .300 BLK rimmed.
    19 replies | 2436 view(s)
  • cwlongshot's Avatar
    Today, 10:11 AM
    Go get another!! Try to make it a rescue you can help save another!! As I said the joys they bring cannot be measured. Here is a pic of my Roxy, doing what she does watching TV with me.
    38 replies | 417 view(s)
  • Hi-Performance Bullet Coatings's Avatar
    Today, 08:18 AM
    These are a pic of TruBlu as done by Slide, he had issues posting the pic so I posted his pic for him. I am sure he will chime in and supply details of his procedure.
    13107 replies | 2062795 view(s)
  • Walks's Avatar
    Today, 02:07 AM
    Wouldn't that be .327 Fed Mag. And It's a light cartridge. If you're going to put it in a heavy rifle, you might as well go with a bigger cartridge. I think the 1st batch of 1894CL's in .32-20 were Great Guns. Wish I still had mine. And...
    12 replies | 333 view(s)
  • Outpost75's Avatar
    Yesterday, 11:50 PM
    I believe that you can still get them from Ruger. If this is incorrect somebody please post the current info.
    7 replies | 139 view(s)
  • cwlongshot's Avatar
    Yesterday, 07:56 PM
    Sorry to read this. Hate to read these actually. But part of life is death and none of us make it “out” alive. I dread the day. Have experienced it it’s never fun and the current is expected to be the worst. My first “lap dog” 19# Lahasa and my...
    38 replies | 417 view(s)
  • cwlongshot's Avatar
    Yesterday, 07:51 PM
    I get same in one Marlin ‘94. My newer Cowboy dosent do it. So I agree generous chamber. I have shot some healthy RUGER loads pushing 300’s to 1600 to see it. Worst is brass probably won’t last as long. But I have had that rifle for over twenty...
    20 replies | 401 view(s)
  • Outpost75's Avatar
    Yesterday, 07:15 PM
    NOT a brass problem. A sloppy chamber and excessive case sizing problem.
    20 replies | 401 view(s)
  • Walks's Avatar
    Yesterday, 07:12 PM
    I will put You in My Prayers tonight. I know how hard it is to watch a Parent suffer until the end. We had to do it twice. My Wife and I are hanging on by our fingernails too. Prayers help sooth the Soul.
    21 replies | 146 view(s)
  • Walks's Avatar
    Yesterday, 07:03 PM
    Walks replied to a thread Biscuits and gravy in Cookin' Recipe's
    It's so blasted easy to make. My Wife does the shopping tomorrow, and I'm bad sick. Gonna tell Her I need some Serious COMFORT FOOD. Biscuits and gravy for Dinner tomorrow night. I can almost taste it NOW.
    103 replies | 6941 view(s)
  • Walks's Avatar
    Yesterday, 06:57 PM
    I still get Handloader & Rifle. My Wife gives Me the 2yr Subscriptions as a Birthday Present every other year. I don't want to upset the Apple cart so I take it and read them. I Read it with a BIG grain of SALT. One of their writers did and...
    10 replies | 278 view(s)
  • cwlongshot's Avatar
    Yesterday, 05:32 PM
    Well that’s a big one! My first attempt set at 400 left a pool of lead with a couple lumps. Ironically it was red HF and looked omanis. Temps on these cheap ovens can be all over the map
    54 replies | 1948 view(s)
  • Outpost75's Avatar
    Yesterday, 04:35 PM
    You should have some reading material in your mailbox. Feel free to contact me again if I can be of further help.
    4 replies | 144 view(s)
  • Outpost75's Avatar
    Yesterday, 03:32 PM
    If you get into reloading .32 ACP in a major way, you will find that mixed headstamp, range pickup brass varies greatly in wall thickness and is rather a nuisance. Dealing with it is a fool's errand and poor economy. As one who has over 50 years...
    4 replies | 144 view(s)
  • Outpost75's Avatar
    Yesterday, 03:25 PM
    Too hot for the chamber dimensions. You are asking alot of the brass to expand that much and seal a sloppy chamber. The .45 Colt, .44 Magnum, .357 were not designed for lever-action use. To make a cylindrical case feed reliably in a...
    20 replies | 401 view(s)
  • cwlongshot's Avatar
    Yesterday, 02:29 PM
    I like my 222/20 better than my later, bigger & heavier 223/20 Savage. That 222 is a earlier model and much lighter. Shoots great too regulation is MUCH closer than the 223/20. Not much difference as the 223 is a 1:14 so it won’t shoot heavier than...
    33 replies | 2115 view(s)
  • cwlongshot's Avatar
    Yesterday, 02:17 PM
    Just called Keystone. (Not real happy with them.) Dispite the lip service they acknowledge the order but it’s not gonna ship till “possibly” end of this week. They say my dealer called up a few days after my order and ordered a stocking order. She...
    33 replies | 2115 view(s)
  • Outpost75's Avatar
    Yesterday, 01:36 PM
    Chamber is too large. Measure diameter of fired case at the bulge. Expect that it is over .485" Load is probably too hot. Dies size the brass too much. Measure your sized cases, expect they are smaller in body diameter than .475" Look...
    20 replies | 401 view(s)
  • cwlongshot's Avatar
    Yesterday, 07:37 AM
    You should not be seeing leading. What’s the dia? Hardness with PC at sub 1k is moot. I have shot dead soft to straight Lino PCd zero issues multiple Glock bbls. Are you crimping heavily? Said before but your sure the PC is cured...
    54 replies | 1948 view(s)
  • cwlongshot's Avatar
    Yesterday, 07:34 AM
    I loaded my oven with lava rock. It helps allot with even heat but needs to be warmed. So I run the oven full timer before first bake. I keep two baskets on top and warm bullets in there before coating. It absolutely helps! My bullets make it just...
    24 replies | 374 view(s)
More Activity
About Walks

Basic Information

About Walks
Biography:
Reloading 59yrs, Shooting 59yrs, Casting 55yrs.
Location:
SoCal
Interests:
Reloading,Rifles,Revolvers,casting,reading
Occupation:
Disabled

Signature


I HATE auto-correct


Happiness is a Warm GUN & more ammo to shoot in it.

My Experience and My Opinion, are just that, Mine.

Statistics


Total Posts
Total Posts
1,807
Posts Per Day
1.34
General Information
Last Activity
Today 01:49 PM
Join Date
06-13-2016
Referrals
0

9 Friends

  1. BorderBrewer BorderBrewer is offline

    Boolit Buddy

    BorderBrewer
  2. Calamity Jake Calamity Jake is offline

    Boolit Master

    Calamity Jake
  3. cwlongshot cwlongshot is offline

    Boolit Master

    cwlongshot
  4. Dieselhorses Dieselhorses is offline

    Boolit Master

    Dieselhorses
  5. Hamish Hamish is online now

    Boolit Master

    Hamish
  6. Hi-Performance Bullet Coatings
  7. jetsfan-24 jetsfan-24 is offline

    Boolit Buddy

    jetsfan-24
  8. Outpost75 Outpost75 is offline

    Boolit Grand Master

    Outpost75
  9. sniper sniper is offline

    Boolit Master

    sniper
Showing Friends 1 to 9 of 9
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check