Inline FabricationRepackboxWidenersADvertise here
Lee PrecisionRotoMetals2Titan Reloading

Tab Content
  • Drm50's Avatar
    Yesterday, 11:21 AM
    I have my KaBar I brought home over 50yrs ago. It is a good knife and holds excellent edge but is on the big side for most field dressings.
    18 replies | 302 view(s)
  • Drm50's Avatar
    Yesterday, 11:10 AM
    Chambers in Ruger must be enough oversize that your load isn't sealing case. This can also cause primer backout and possible punctures.
    17 replies | 324 view(s)
  • Drm50's Avatar
    02-14-2020, 07:28 PM
    I would say in $50 neighborhood. Nice K Magnas can be had for $25 up. They are probably the most common of all S&W grips. Thousands of S&W K frames were used by law enforcement and most had Magna grips.
    10 replies | 217 view(s)
  • Drm50's Avatar
    02-12-2020, 05:57 AM
    I wheel and deal S&Ws, P&R era or older. It aggravates me that rubber grips are put on S&Ws and stock grips sold separately. They only do this because buyers are to stupid to dock the price the value of a set of factory grips. You can find same...
    30 replies | 771 view(s)
  • Drm50's Avatar
    02-11-2020, 10:23 PM
    A early S&W m41 like new condition. Haven't got to shoot it yet.
    127 replies | 3143 view(s)
  • Drm50's Avatar
    02-11-2020, 12:31 PM
    I had the base on my 1895 on to overhang front of action. Because of position of adjustment turret on scope I had to get movement to get eye relief. A lot of the new generation scopes have shorter tubes and less adjustment travel between rings. ...
    9 replies | 245 view(s)
  • Drm50's Avatar
    02-10-2020, 12:54 AM
    Nice job, I've always liked Stevens 94/ Savage 220 series better than H&R and IJs. I have a original 94 in 12g that has case hardened reciever. Gun is near mint. Have another 94b that I need wood for. Not easy to find. Small differences in forend...
    14 replies | 1084 view(s)
  • Drm50's Avatar
    02-08-2020, 09:41 AM
    32cal from handgun is not a practical choice for deer. It is marginal at best in a rifle. Yea it will kill them under idea conditions, so will a 22rf.
    42 replies | 1743 view(s)
  • Drm50's Avatar
    02-07-2020, 07:44 PM
    I’ve had 3 smokeless action RBs. Two 7mms and a 30/40. Shot 30/40 a good bit with 200cast and mild load of IMR-3031. I remember vel to be about 2000fps.
    19 replies | 2172 view(s)
  • Drm50's Avatar
    02-07-2020, 07:35 PM
    I live in Ohio, no large animals to attack. I fooled with a lot of 22s to find perfect loafing gun. This is carried while wade fishing and while engaged in other outdoor activities other than hunting. The gun has to be accurate enough that it’s...
    75 replies | 4156 view(s)
  • Drm50's Avatar
    02-07-2020, 03:30 PM
    I shot a deer with 185gr WC at 750fps. 40yds, kilt it dead, it did flop for a few seconds but through shot had a great effect on its oil pressure. 44special.
    55 replies | 1613 view(s)
  • Drm50's Avatar
    02-07-2020, 03:23 PM
    This past fall my bro bought Bulk Browning 22 ammo at Cabelas. We were shooting several rifles and handguns and the Brn ammo was terrible in S&W revolvers, Ruger auto pistols and several rifles including 10/22s. It was dirty, inaccurate and high...
    11 replies | 747 view(s)
  • Drm50's Avatar
    02-07-2020, 12:19 PM
    I'm not sure but I think I bought them from Brownells. I'm sure they are avaiable in SS. In fact I think I have seen them in either torx or Allen style heads. Mine are standard slots and blue.
    17 replies | 1128 view(s)
  • Drm50's Avatar
    02-07-2020, 12:03 PM
    I have a SBH from 1964. I always had to check the screws for each shooting session. I had a screw shear off from once. I bought a set of replacement screws with nylon inserts and have had no futher trouble.
    17 replies | 1128 view(s)
  • Drm50's Avatar
    02-06-2020, 03:28 PM
    Drm50 replied to a thread First Lever Action? in Leverguns
    I have used levers for woods deer hunting since I started in 60s. 100yd and less there is no need for BA accuracy. Had a Marlin 1897 22 since I was a kid. I don't do cast for 30/30 but do for 25/20, 32/20, 38/55, 45/70 and pistol cartridges. Most of...
    30 replies | 1050 view(s)
  • Drm50's Avatar
    01-22-2020, 01:27 PM
    There is to much over thinking on cartridges and bullets for deer. A 30/06 is plenty of gun for deer and the best bullet is the one your rifle shoots best. All the Hunter has to do is make a decent shot. Gimmick bullets don't make up for poor shots.
    52 replies | 2998 view(s)
No More Results
About Drm50

Basic Information

About Drm50
Biography:
Army vet..ex coal miner
Shooting & fishing before I could walk
Location:
SE Ohio
Interests:
Hunting,Fishing, Gun Collecting
Occupation:
Contractor

Statistics


Total Posts
Total Posts
1,530
Posts Per Day
1.13
General Information
Last Activity
Today 06:15 PM
Join Date
06-08-2016
Referrals
0
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check