Inline FabricationWidenersRotoMetals2Repackbox
StainLess Steel MediaGraf & Sons

Tab Content
  • GONRA's Avatar
    01-11-2019, 07:54 PM
    GONRA gotta gallon can of ALOX 2128 after the American Rifleman's waaaaaay back original article. Been using "Pure ALOX 2138" (no beeswax) asa bullet lube (auto pistol cartridges) for decades. Lube grooves are located in the neck of the loaded...
    28 replies | 2481 view(s)
  • GONRA's Avatar
    01-05-2019, 08:49 PM
    GONRA sez - when you buy an olde lathe (cheep, right?) make SURE there is a chuck on it. Lathe may be cheep - chucks aren't unless you luck out. Single phase AC "home electric" motor helps too.....
    18 replies | 703 view(s)
  • GONRA's Avatar
    01-05-2019, 08:39 PM
    GONRA sez - most (all)? of us can pick up Range Brass, Reload and Blast Away Just Fine. (Clean dirt off, weed out Berdan primed / tiny flash hole Boxer brass FIRST!) Yer air compressor is yer Friend on his stuff.....
    22 replies | 1109 view(s)
  • GONRA's Avatar
    12-29-2018, 07:50 PM
    GONRA replied to a thread 9mm STEYR in Case Forming / Re-forming
    GONRA sez - 9mm Steyr cartridge case head diameter is smaller than .38 ACP, .38 Super, 9mm Bergman-Bayard, 9mm Largo....
    13 replies | 1146 view(s)
  • GONRA's Avatar
    12-22-2018, 05:56 PM
    GONRA replied to a thread Unknown press in Reloading Equipment
    GONRA asks - is the frame cast aluminum? Bet some guy "just made it".
    8 replies | 773 view(s)
  • GONRA's Avatar
    12-21-2018, 06:54 PM
    GONRA wants ya'll who melt Higher Melting Point Stuff to be aware of "Grobet USA Digital Melting Furnaces for Casting and Fusing alloys": 110 Volt - (3 types: 850 watt, 1300 watt, 1700 watt) all 2012 deg. F.) Get 'em at: Penn Tool Co.,...
    11 replies | 627 view(s)
  • GONRA's Avatar
    12-19-2018, 09:30 PM
    GONRA's not sure if anyone commented above on azrednek's "too small 1930's FA .45 ACP brass primer pockets". That's because these were 0.204 inch diameter (not 0.210 inch diameter.) Sometime AFTER WWII everyone started using 0.210 inch...
    86 replies | 36464 view(s)
No More Results
About GONRA

Basic Information

Statistics


Total Posts
Total Posts
425
Posts Per Day
0.39
General Information
Last Activity
01-16-2019 07:40 PM
Join Date
01-24-2016
Referrals
0
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check