RotoMetals2ADvertise hereLee PrecisionInline Fabrication
MidSouth Shooters SupplyGraf & SonsTitan ReloadingStainLess Steel Media

  • oldblinddog's Avatar
    04-28-2018, 10:32 PM
    The temperature difference was likely about 30* (+/-) between the two. The biggest reason I went to the 100 yd. line is that I wanted to take advantage of the no wind conditions which are unusual in North Texas. The winds on the above RL22 tests...
    4 replies | 352 view(s)
  • oldblinddog's Avatar
    04-28-2018, 07:17 PM
    I received a supply of Accurate 4350 yesterday and proceeded to load test rounds. Everything is the same as above with the exception of the powder which is Larry’s load of 47.0 grains. I had several bullets go out of the group. One was my fault....
    4 replies | 352 view(s)
  • oldblinddog's Avatar
    04-20-2018, 03:43 PM
    Bullets were cast from a mix of Rotometals hardball and 16-1 that results in a ratio of ~94.6/2.7/2.7. They were air cooled and then aged about 3 weeks prior to sizing to 0.310” and loading. Lube is Carnauba Red 2700+. They were not sorted in any...
    4 replies | 352 view(s)
No More Results
About oldblinddog

Basic Information

About oldblinddog


USMC 6638


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
05-16-2018 09:58 PM
Join Date
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check