Titan ReloadingRotoMetals2MidSouth Shooters SupplyInline Fabrication
StainLess Steel MediaGraf & SonsWidenersLee Precision

Tab Content
  • Nueces's Avatar
    Today, 05:37 PM
    I think the best alternative for seating fat slugs is the Hornady sliding sleeve seater. The sleeves are simple cylinders with a stepped inside diameter for case neck and bullet, easy to alter or make from scratch, given access to the simplest of...
    5 replies | 60 view(s)
  • frkelly74's Avatar
    Today, 05:22 PM
    As said before it might be the die set you are using, in which case the new brass will eventually not chamber either. I seem to remember that Redding dies (yeah the expensive ones) were cut to correspond with the 1911 chamber dimensions. I would be...
    10 replies | 531 view(s)
  • frkelly74's Avatar
    Today, 05:11 PM
    I set the bait under a mercury vapor light and could see the raccoons perfectly. The 513 with its long barrel makes very little noise with sub sonic ammo.
    5 replies | 38 view(s)
  • Down South's Avatar
    Today, 04:23 PM
    Down South replied to a thread Whole Home Generator in Our Town
    I'm in Houston, my generator is in central La. I see on my phone app that the generator came on twice today due to power outages. We have some storms going through right now and I figure that a storm knocked out power to the house a couple times...
    34 replies | 735 view(s)
  • Sweetpea's Avatar
    Today, 04:01 PM
    The biggest mule deer in the world inhabit the Arizona strip and the Kaibab plateau. But, it takes many years to draw a tag.
    18 replies | 233 view(s)
  • W.R.Buchanan's Avatar
    Today, 02:41 PM
    Have you seen the "Ravin Crossbow?" They advertise 3" groups at 100 yards! which for a Crossbow is unheard of. I'm pretty sure we can get that good with our Smooth Bore Shotguns, we just have to find the right projectile. The problem with...
    106 replies | 2002 view(s)
  • trooperdan's Avatar
    Today, 02:38 PM
    Comparing the two, I'd say the value of the box has increased, just me.
    60 replies | 2209 view(s)
  • Larry Gibson's Avatar
    Today, 02:06 PM
    Larry Gibson replied to a thread 30-30 load request in Leverguns
    Scoped Marlin with 150 RN at 2350 fps; Zero at 175 yards, 2.75" high at 100 yards Is 2.75" low at 200 yards Is 10" low at 250 yards with 1450 fps remaining. Doable with 150 RN and LvR powder.....much better with the Hornady 160 FTX with...
    20 replies | 408 view(s)
  • trooperdan's Avatar
    Today, 01:52 PM
    Some of these are RCBS, some are Lyman, if that makes a difference to you, let me know and I'll confirm manufacture. All are new or as new. .251 .280 .311 .355 (have 2) .357 . Above $25 each shipped,
    0 replies | 84 view(s)
  • Tom W.'s Avatar
    Today, 01:45 PM
    I remember when I used to get 60 pound lead ingots from Sanders lead. I had to take them to the place where my son worked and use their cutting torch to make them usable. They sure absorb the heat!
    23 replies | 744 view(s)
  • waksupi's Avatar
    Today, 01:32 PM
    waksupi replied to a thread Santa Fe, NM in Our Town
    I stayed at some friends hacienda a couple blocks off of Canyon Road for a few weeks. I didn't even know there was a "new" part of town until I was nearly ready to leave. I did find one interesting place, I think it is called Jackalope. I remember...
    17 replies | 386 view(s)
  • waksupi's Avatar
    Today, 01:27 PM
    I've had the same experience. When a business advertises as Christian owned and operated, I've learned to not do business there, because sure as shooting, they will try to screw the customer.
    33 replies | 636 view(s)
  • 2ndAmendmentNut's Avatar
    Today, 01:13 PM
    Sold! Sent from my iPhone using Tapatalk
    8 replies | 327 view(s)
  • Calamity Jake's Avatar
    Today, 01:10 PM
    Here you go: http://superiorgage.com/precision-instruments/4658482?cam=ppc-g-m126174-c535637-g1303883-gage+servicego there in Okla. As a quality control manager I used them all the time for machine shop gage calibration and repair.
    3 replies | 100 view(s)
  • Hardcast416taylor's Avatar
    Today, 01:01 PM
    Probably either cupro nickel or mild steel.Robert
    2 replies | 80 view(s)
  • waksupi's Avatar
    Today, 01:01 PM
    Lance, would you please start using smaller font? This is hard to read.
    11 replies | 158 view(s)
  • 2ndAmendmentNut's Avatar
    Today, 12:42 PM
    Going once! Sent from my iPhone using Tapatalk
    8 replies | 327 view(s)
  • Thumbcocker's Avatar
    Today, 12:15 PM
    didn't make it there.
    5 replies | 79 view(s)
  • Thumbcocker's Avatar
    Today, 11:58 AM
    We sent two nights at the campground in Green River State Park. The campsites are spacious and grass covered. Each campsite has a parking space, picnic table, grill, potable water spigot and electricity. Our plan was to take a day off from traveling...
    5 replies | 79 view(s)
  • Sweetpea's Avatar
    Today, 11:51 AM
    I live about 3 1/2 hours from there, and occasionally have to head over there for a week at a time. Housing is MUCH cheaper there than here, for a reason. About the only thing that gets me excited thinking about page is the really good pizza...
    18 replies | 233 view(s)
  • Char-Gar's Avatar
    Today, 11:26 AM
    Char-Gar replied to a thread Santa Fe, NM in Our Town
    There is much to see, do and eat in Santa Fe. The fall after the summer tourist season is a great time to go. I have been there many times and will do back, God willing. In fact it is my favorite town in this country, but I am a squirrely kind of...
    17 replies | 386 view(s)
  • RU shooter's Avatar
    Today, 11:25 AM
    That's them ! Thanks for the pictures and info, always admired the looks of those old sporting mausers .maybe one day I'll stumble across one .
    5 replies | 153 view(s)
  • Char-Gar's Avatar
    Today, 11:19 AM
    The British 200 grain load you spoke of is a 38 S&W round and not 38 Special. There was a 200 grain blunt round nose 200 grain lead bullet load in the 38 Special that was called (I think) a Super Police Load. Frankly these heavy blunt nose 38...
    14 replies | 128 view(s)
  • Larry Gibson's Avatar
    Today, 11:14 AM
    Larry Gibson replied to a thread 30-30 load request in Leverguns
    30calflash If your Marlin has a 20" barrel then 200 yards is realistic with the 150s using LvR powder. With the 160 FTX Hornady 250 is very doable. If you've a 24" barrel then 300 yards is certainly possible. With a 20" barrel expect...
    20 replies | 408 view(s)
  • Char-Gar's Avatar
    Today, 11:06 AM
    You have asked a valid question and one I have pondered on. There are videos out there showing standard factory target wadcutters giving great penetation in gel. These little lead kegs are moving along at 650 or so fps. So, why soup them up to 850...
    31 replies | 3911 view(s)
More Activity
About Bob Krack

Basic Information

Date of Birth
August 3, 1943 (75)
About Bob Krack
Ohio for a while Kalifornia then who knows where - Missouri?
alternative energy, casting & shooting
construction millwright - steam turbines and material handling equipment


I was always taught to respect my elders, but it's getting harder and harder to find any!

Μολὼν λαβέ; approximate Classical Greek pronunciation [molɔ̀ːn labé], Modern Greek [moˈlon laˈve]), meaning "Come and take them" is a classical expression of defiance reportedly by King Leonidas in response to the Persian army's demand that the Spartans surrender their weapons at the Battle of Thermopylae.


Total Posts
Total Posts
Posts Per Day
Total Albums
Total Photos
General Information
Last Activity
06-16-2013 11:06 AM
Join Date

248 Friends

  1. 003402 003402 is offline

    Boolit Bub

  2. 1kshooter 1kshooter is offline

    Boolit Master

  3. 1Shirt 1Shirt is offline

    Boolit Master

  4. 280Ackley 280Ackley is offline

    Boolit Master

  5. 2ndAmendmentNut 2ndAmendmentNut is offline

    Boolit Master

  6. 3006guns 3006guns is offline

    Boolit Master

  7. 303Guy 303Guy is offline

    Boolit Master

  8. 340six 340six is offline

    Boolit Master

  9. 358wcf 358wcf is offline

    Boolit Master

  10. 376Steyr 376Steyr is offline

    Boolit Master

Showing Friends 1 to 10 of 248
Page 1 of 25 1234567891011 ... LastLast
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check