Inline FabricationWidenersLee PrecisionRotoMetals2
StainLess Steel MediaMidSouth Shooters SupplyGraf & SonsTitan Reloading
Repackbox
Tab Content
  • jcren's Avatar
    10-17-2018, 05:35 PM
    jcren replied to a thread 1st one of 2018 in Hunting with CB's
    Got this one Saturday. Not a monster, but for me, archery has been tough for a few seasons so I am pleased as punch. Btw, those are slick trick magnums on home built 500 grain shafts.
    10 replies | 605 view(s)
  • jcren's Avatar
    10-16-2018, 12:42 PM
    The transparent colors dont work for me, but the opaque seem to work about the same. Have black, matte white and od green that all work
    5 replies | 232 view(s)
  • jcren's Avatar
    10-16-2018, 07:59 AM
    Cfe had become my favorite full power powder for 380 and 45 acp. Suprising velocity with a milder recoil pulse than comperable hs-6 or autocomp and almost no flash. My defense 380 will run 95 grains at 925 from my tcp with only a dull orange-red...
    18 replies | 363 view(s)
  • jcren's Avatar
    10-12-2018, 10:35 AM
    I believe Sage offers over sized 30 cal checks for 303. I would check with him.
    5 replies | 196 view(s)
  • jcren's Avatar
    10-10-2018, 08:36 PM
    jcren replied to a thread High Point 9mm Carbine. in Cast Boolits
    Love my 45. Shoots great, reliable until i pushed the +p too far (200 grain @1350 fps) then it started jamming. After i killed a 200 plus pound hog at 70yards (pass through just behind the shoulder) with my general plinking load i realized i was...
    18 replies | 575 view(s)
  • jcren's Avatar
    10-09-2018, 07:30 PM
    jcren replied to a thread 458 Socom fail in Cast Boolits
    You will need something to keep the pc from sticking to thray. Parchment paper or nonstick aluminum foil work best and are available at Wal-Mart, grocery store etc in the baking stuff. Nonstick foil only, and it has a plain and nonstick side. Plain...
    26 replies | 852 view(s)
  • jcren's Avatar
    10-09-2018, 06:22 PM
    jcren replied to a thread 458 Socom fail in Cast Boolits
    Dont sweat the bases. If you get em clean and set em on parchment paper or nonstick foil you will get good coverage on the bases, but it isnt needed. Just look at fmj pistol bullets, exposed lead bases. Just tumble lube the screw ups in lee alox or...
    26 replies | 852 view(s)
  • jcren's Avatar
    10-09-2018, 12:29 PM
    jcren replied to a thread 458 Socom fail in Cast Boolits
    Yep, that is a wax lube. Should be able to boil them in water to float off the lube. Skim or pour all the lube off before fisbhing out the bullets. Might roll em in a towel with acetone or lacquer thinner after boilingto make sure.
    26 replies | 852 view(s)
  • jcren's Avatar
    10-07-2018, 07:48 PM
    On the powder note, hs-6 and the new cfe pistol are awsome for 380, especially at 100+ grains
    39 replies | 1119 view(s)
  • jcren's Avatar
    10-07-2018, 07:43 PM
    Saw a slow motion of shooting one of those. It was so well regulated that the bullets actually hit each other at about 12 yards and hit the target about 2" apart at 15. Cool feat of engineering.
    6 replies | 257 view(s)
  • jcren's Avatar
    10-07-2018, 09:23 AM
    jcren replied to a thread Prayer Request in Our Chapel
    Prayers sent
    13 replies | 252 view(s)
  • jcren's Avatar
    10-07-2018, 09:16 AM
    jcren replied to a thread Prayer Request in Our Chapel
    Prayers sent
    13 replies | 252 view(s)
  • jcren's Avatar
    10-07-2018, 07:40 AM
    I use mostly the lee 95 rf version of the ranchdog in my 380's but the wide meplant can be picky about oal, especially in my tcp. I do have and have loaded the lee 120 and it fed and shot flawlesly, but recoil was sharp with warm loads. Would work...
    39 replies | 1119 view(s)
  • jcren's Avatar
    10-05-2018, 10:39 PM
    jcren replied to a thread Copperheads in Our Town
    Local guy had a toe amputated after being bit by a 8" baby when he was wearing sandals. If they are crawling they are big enough to hurt ya.
    48 replies | 1904 view(s)
  • jcren's Avatar
    10-02-2018, 09:55 PM
    Got one for my girls. Shoots fairly accurate, feeds mini-mags and the like flawless, but cheap ammo is hit or miss. Simple trigger group, a little light stoning and squeezing the hairpin hammer spring a bit did wonders for trigger pull. Light, fun...
    12 replies | 273 view(s)
  • jcren's Avatar
    10-02-2018, 07:45 AM
    Prayers sent
    16 replies | 273 view(s)
  • jcren's Avatar
    09-30-2018, 11:12 AM
    jcren replied to a thread Game Changer in Hunting with CB's
    Once the sobs move in, you got em for life. They aren't actually as tough as you hear, old big boars can have a heavy shield over their shoulders from fighting, but sows and smaller pigs aren't bullet proof. Have killed several including a near 200...
    40 replies | 2215 view(s)
  • jcren's Avatar
    09-25-2018, 07:55 PM
    Haven't done it myself, but was told to drive a lead slug to the port position and drill slowly and the slug would prevent internal burrs. Just a thought.
    15 replies | 440 view(s)
  • jcren's Avatar
    09-23-2018, 04:51 PM
    I use airsoft bbs with smokes powders. Don't know if it helps good powder stick, but certainly helps with damp or old powders. After swirling for 30 seconds or so, a dozen hard up/down shakes really evens out the coverage.
    16 replies | 646 view(s)
No More Results
About jcren

Basic Information

About jcren
Biography:
Happily married(went to the range for her b-day!), 4 kids, love anything mechanical
Location:
South, Central Ok
Interests:
if it goes fast, makes noise or looks cool, i am there
Occupation:
Copier sales, "promoted" from tech. Tech again thank God!

Signature


"In God we trust, in all others, check the manual!"

Statistics


Total Posts
Total Posts
1,663
Posts Per Day
1.16
General Information
Last Activity
Today 08:02 AM
Current Activity
Viewing Thread Recycling Powder Coated bullets
Join Date
11-22-2014
Referrals
0

1 Friend

  1. ProudOkie ProudOkie is offline

    Boolit Bub

    ProudOkie
Showing Friends 1 to 1 of 1
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check