RepackboxMidSouth Shooters SupplyTitan ReloadingLee Precision
WidenersADvertise hereRotoMetals2Inline Fabrication

Tab Content
  • dale2242's Avatar
    07-09-2020, 07:39 AM
    My wife fries it like you would chicken until done and golden brown and then pressure cooks it for 15-20 minutes. Some of those old timers have been running through those trees for some time and can be quite tough if just fried.
    25 replies | 2242 view(s)
  • dale2242's Avatar
    07-06-2020, 09:09 AM
    Yes, The iron ones get a light coating of Remoil. It is humid here in SW Oregon in the winter...dale
    38 replies | 729 view(s)
  • dale2242's Avatar
    07-06-2020, 08:58 AM
    Wasn`t WANDA the see through clear plastic shot shells? I still have one in my shell collection....dale
    16 replies | 808 view(s)
  • dale2242's Avatar
    07-03-2020, 05:53 AM
    I have said this on this forum a number of times. My FTFs have always been the fault of the gun not the primer. I have had very few and I have been loading a lot each year for 50+ years. Your results may vary.
    15 replies | 567 view(s)
  • dale2242's Avatar
    07-03-2020, 05:39 AM
    I use extended shell holders for short cases like 22 Hornet.
    7 replies | 246 view(s)
  • dale2242's Avatar
    07-03-2020, 05:36 AM
    When I get smear on the sprue plate I heat it evenly with a propane torch ad wipe the molten smear off with a COTTEN cloth, not synthetic. Some are concerned about warping the plate by heating it with a torch but I haven`t had that problem by...
    25 replies | 573 view(s)
  • dale2242's Avatar
    07-03-2020, 05:19 AM
    dale2242 replied to a thread Thank You in Our Town
    I am an old guy that has been casting for over 50 years. I hope the knowledge I have passed on has helped some. I have learned a lot from this site and and am still learning...dale
    14 replies | 385 view(s)
  • dale2242's Avatar
    07-03-2020, 05:14 AM
    We have had lettuce, spinach, broccoli, and artichokes from our garden so far. The garlic is harvested and curing as we speak. Hot weather crops are ways off yet, but looking good
    4 replies | 953 view(s)
  • dale2242's Avatar
    07-02-2020, 06:58 AM
    dale2242 replied to a thread Ruger PC 9mm Carbine in Cast Boolits
    3.6 gr 700X with 120gr Lee TC bullet worked fine in my grandsons gun with a quick 5 round rapid fire test. Bullet cast from lino with 50/50 lube. I have just cast some from #2. I will post when we get more results.
    26 replies | 787 view(s)
  • dale2242's Avatar
    07-01-2020, 08:46 AM
    I have sized and lubed at the same time .321 bullets down to .315 with no issue. I use 50/50 lube. I don`t know if that makes a difference or not.
    14 replies | 402 view(s)
  • dale2242's Avatar
    06-27-2020, 07:42 AM
    dale2242 replied to a thread What state are you from? in Our Town
    Cave Junction, Oregon
    145 replies | 4738 view(s)
  • dale2242's Avatar
    06-26-2020, 08:40 AM
    dale2242 replied to a thread Bear Toys in Our Town
    Bears will bite things to taste them. Trying to see if it contains something good to eat.
    7 replies | 859 view(s)
  • dale2242's Avatar
    06-25-2020, 06:59 AM
    Deprime before wet tumbling.
    12 replies | 349 view(s)
  • dale2242's Avatar
    06-25-2020, 06:44 AM
    dale2242 replied to a thread Server upgrade in Our Town
    Seems fine here
    416 replies | 9945 view(s)
  • dale2242's Avatar
    06-22-2020, 03:47 PM
    A seafood extravaganza off the Pit Boss grill. Shrimp, scallops, oysters, salmon and chicken kabobs.
    18 replies | 1077 view(s)
  • dale2242's Avatar
    06-19-2020, 07:58 AM
    dale2242 replied to a thread Old smokey in Our Town
    I still have the one we used when shooting silhouettes. You put carbide and water in it to produce acetylene that produces very thick black smoke when the wick is lit, You use to blacken sights...dale.
    13 replies | 1715 view(s)
  • dale2242's Avatar
    06-15-2020, 07:18 PM
    Do you fill a multi cavity mold from the front or from the back first? I fill mine from the front first.
    37 replies | 2739 view(s)
  • dale2242's Avatar
    06-15-2020, 09:07 AM
    dale2242 replied to a thread Picking up 9mm brass in Cast Boolits
    i pick up all brass i find, bent or not. Bent goes to scrap yard. i have 5 gallon buckets of brass.
    36 replies | 2371 view(s)
  • dale2242's Avatar
    06-14-2020, 06:45 PM
    dale2242 started a thread Pac Nor Update in Our Town
    A friend and I drove over to Brookings Friday to get out of the valley. While there we decided to stop by where the Pac Nor shop had been to see if they had made any progress since their devastating fire last October. It seems their plans to...
    3 replies | 408 view(s)
  • dale2242's Avatar
    06-12-2020, 09:31 AM
    I did a test with 45ACP using Magnum primers with my standard load. I tested them in 2 different 45s. The load was midrange load of 700X and a 452460 bullet. Magnum primers showed an average increase of 20 FPS in velocity. There was no change...
    31 replies | 2121 view(s)
  • dale2242's Avatar
    06-12-2020, 09:22 AM
    dale2242 replied to a thread Boot Recommendation in Our Town
    Whites are the best boots I have ever worn. Their made-to-measure will fit you perfectly. They are a custom boot which means they are expensive. Believe me, they are worth the money.
    3 replies | 298 view(s)
  • dale2242's Avatar
    06-12-2020, 09:18 AM
    dale2242 replied to a thread Kids firearm instructor in Our Town
    I am a certified ODFW Hunter Ed. instructor. I had a 7 year old pass the class. The material is geared toward kids 12 YO and older. The problem with young kids is that some aren`t big/strong enough to handle the firearms.
    15 replies | 435 view(s)
  • dale2242's Avatar
    06-12-2020, 09:13 AM
    I have been spraying them with Pam before each use. Soaking them over night in water with dawn makes cleanup pretty easy. I never thought of TSP. I will give it a try. How much are you using in each batch?
    19 replies | 939 view(s)
More Activity
About dale2242

Basic Information

About dale2242
Biography:
Born 2-2-1942
Location:
SW Oregon
Interests:
Hunting -Fishing- Shooting - Wood working
Occupation:
Retired Heavy Equipment Operator

Statistics


Total Posts
Total Posts
1,678
Posts Per Day
0.36
General Information
Last Activity
Today 12:36 AM
Join Date
10-10-2007
Referrals
2

8 Friends

  1. 45nut 45nut is offline

    Cast Boolits Founder/B.O.B.

    45nut
  2. Bob Krack Bob Krack is offline

    Boolit Master at Heavens Range

    Bob Krack
  3. Chevy Chevy is offline

    Boolit Dog In Heaven's Range

    Chevy
  4. chuckbuster chuckbuster is online now

    Vendor Sponsor

    chuckbuster
  5. fatnhappy fatnhappy is offline

    Boolit Master and Dean of Balls

    fatnhappy
  6. Love to shoot Love to shoot is offline

    Boolit Mold

    Love to shoot
  7. PatMarlin PatMarlin is offline

    Banned

    PatMarlin
  8. rugerman1 rugerman1 is offline

    Boolit Buddy

    rugerman1
Showing Friends 1 to 8 of 8
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check