Titan ReloadingADvertise hereRepackboxRotoMetals2
WidenersInline FabricationLee Precision

  • M-Tecs's Avatar
    Today, 01:25 AM
    M-Tecs replied to a thread rcbs sidewinder in Swappin & Sellin
    PM sent
    7 replies | 225 view(s)
  • M-Tecs's Avatar
    Today, 01:20 AM
    M-Tecs replied to a thread 1/2" at what range in Rimfire Area
    When scoring normal targets if the bullet touches the line you get the higher value. Per the OP all shots must be inside the 1/2" circle. The group can not touch the line. Group has to be less than .278" center to center if it is perfectly...
    67 replies | 2165 view(s)
  • M-Tecs's Avatar
    Today, 01:09 AM
    M-Tecs replied to a thread rcbs sidewinder in Swappin & Sellin
    Does the motor run?
    7 replies | 225 view(s)
  • M-Tecs's Avatar
    Yesterday, 11:46 PM
    M-Tecs replied to a thread rcbs sidewinder in Swappin & Sellin
    Depending on what works and what doesn't I may be interested. What are you looking for?
    7 replies | 225 view(s)
  • M-Tecs's Avatar
    Yesterday, 07:57 PM
    M-Tecs replied to a thread Winchester 1885 in Single Shot Guns
    Per SAAMI the TD'S are 28,000 CUP/PSI. At 28k they are both the same unit of measure. Lyman and a couple of others reloading manuals recommend lighter but that is not 45/70 SAAMI specs. ...
    8 replies | 395 view(s)
  • M-Tecs's Avatar
    Yesterday, 06:20 PM
    M-Tecs replied to a thread 1/2" at what range in Rimfire Area
    I wish. Strange thing is most people get strangely quiet will they have to back it up with money. I have won three $100 bets on 1,000 yard shots or should I say lack of shots.
    67 replies | 2165 view(s)
  • firefly1957's Avatar
    Yesterday, 05:41 PM
    I recently did a few they barely expand at 357 magnum pistol speeds in water even with a core of compressed shot . Frankly I am happier with cast bullets that are coated and baked in many pistol rounds and a couple rifle rounds. I do think If...
    4 replies | 111 view(s)
  • M-Tecs's Avatar
    Yesterday, 03:29 PM
    M-Tecs replied to a thread 1/2" at what range in Rimfire Area
    To meet the OP's criteria each and ever shot has to be within plus or minus 1/8" of the absolute dead center for both POI and group size. Even at 25 yards with the best ammo and equipment (which I have) I don't believe I would claim I can do it...
    67 replies | 2165 view(s)
  • firefly1957's Avatar
    01-25-2020, 05:37 PM
    I have two rifles I have forward mounted pistol scopes on neither of set up for scopes one is a early Ruger Mini-14 the other is a Remington model 81 in 300 savage . Both have a 2-7 X scope and the idea works well but does effect handling /carrying...
    41 replies | 613 view(s)
  • M-Tecs's Avatar
    01-24-2020, 11:02 PM
    M-Tecs replied to a thread Gunstocks in Our Town
    http://www.treebonecarving.com/winchester-highwall-stocks.html
    5 replies | 233 view(s)
  • firefly1957's Avatar
    01-23-2020, 06:09 PM
    In 1975 I bought my first handgun a S&W model 28 I used it to hunt and for work as a security guard have no idea how mant small criiters I got with it I never deer hunted with it . It was the first round I did a lot of experimenting with and third...
    72 replies | 2724 view(s)
  • firefly1957's Avatar
    01-23-2020, 05:43 PM
    Long before the deer population exploded the Pheasant population dropped in Macomb and Lapeer counties where I hunted it did coincide with the explosion of population of the possum in the area.
    34 replies | 1919 view(s)
  • M-Tecs's Avatar
    01-23-2020, 02:35 AM
    Different type of pistol and different shooting technique but my Remington XP-100 6mm BR will hold 1 1/4" five shot group at 300 yards constantly.
    64 replies | 1396 view(s)
  • randyrat's Avatar
    01-22-2020, 08:17 PM
    I am selling a similar product if your interested in the VS section..As of today just PM me for prices and directions. Mine is called "ZIP LUBE"
    13 replies | 2051 view(s)
  • randyrat's Avatar
    01-22-2020, 08:51 AM
    A while ago I ran a similar test, although my bullets where all sized at .451...I believe the TAC 1 gained me dang near 2" at 75' with about 2 different shake on lubes. Now TAC 1 is my go to for bullseye shooting, 45 acp 4 gr bullseye h&g68 clone,...
    17 replies | 715 view(s)
  • M-Tecs's Avatar
    01-21-2020, 08:19 PM
    CZ 452 do not have a set trigger. The 453 does.
    15 replies | 428 view(s)
  • firefly1957's Avatar
    01-21-2020, 06:56 PM
    The dust is very Flammable too!
    41 replies | 1332 view(s)
  • firefly1957's Avatar
    01-21-2020, 06:55 PM
    I have used and even mixed all the H.F. powders red cures the easiest and black needs to bake longer mostly I apply it wet* then stand them on Silicone baking sheet to cook/cure . I have only used the electrostatic sprayer with the red color never...
    33 replies | 2096 view(s)
  • firefly1957's Avatar
    01-21-2020, 09:39 AM
    I know I saw a site like that in Lapeer state game area (at one time it was called bass lake) where a lake dried up and deer were rooting in the muck I too wondered just what they were after . As far as deer licking one another they are very social...
    34 replies | 1919 view(s)
  • firefly1957's Avatar
    01-21-2020, 09:31 AM
    I have only looked in Winter as I rarely have cameras out in summer then there is the ability to read tracks much better in the snow rather then in ground growth.
    34 replies | 1919 view(s)
  • M-Tecs's Avatar
    01-21-2020, 05:34 AM
    M-Tecs replied to a thread Winchester 1885 in Single Shot Guns
    Since it started life as a 32-40 and was rebored I am assuming is an original?? If so dates of manufacture become somewhat important. Winchester started using stronger steels in the barrels around 1894 for the 94's and the 95's. Not sure when...
    8 replies | 395 view(s)
  • M-Tecs's Avatar
    01-21-2020, 01:45 AM
    Not really sure about statement about milk or buttermilk changing the taste? I have never found that to be true unless it was to remove foreign tastes like sage or the iron taste of excess blood. Deer or antelope that have been feeding on sage...
    51 replies | 1135 view(s)
  • M-Tecs's Avatar
    01-21-2020, 01:28 AM
    megasupermagnum is spot on. Case volume will determine pressure. Some slow powders do odd things with too low of pressure. Powders like Unique work very well with the same charge in the 45 Colt and the 45/70 so loads like these would be fine for...
    21 replies | 382 view(s)
More Activity
About Shooter6br

Basic Information

Date of Birth
April 12, 1956 (63)
About Shooter6br
Biography:
Age 58 married (with 2 sons) Christian

Facebook......thekellners@aol.com
Location:
Warminster Pa. ( North of Filthydelphia)
Interests:
Shooting, Photography Member Bucks County Fish and Game
Occupation:
R.N

Statistics


Total Posts
Total Posts
1,807
Posts Per Day
0.40
General Information
Last Activity
11-09-2018 01:03 PM
Join Date
10-02-2007
Referrals
0

13 Friends

  1. Bob Krack Bob Krack is offline

    Boolit Master at Heavens Range

    Bob Krack
  2. cheese1566 cheese1566 is offline

    Boolit Master

    cheese1566
  3. firefly1957 firefly1957 is offline

    Boolit Master

    firefly1957
  4. GARCIA GARCIA is offline

    Boolit Master at Heaven's Range

    GARCIA
  5. gray wolf gray wolf is offline

    Boolit Master

    gray wolf
  6. HiVelocity HiVelocity is offline

    Boolit Master

    HiVelocity
  7. LuvMy1911 LuvMy1911 is offline

    Boolit Man

    LuvMy1911
  8. M-Tecs M-Tecs is offline

    Boolit Grand Master

    M-Tecs
  9. Phillip Phillip is offline

    Boolit Buddy

    Phillip
  10. randyrat randyrat is offline

    Vendor Sponsor

    randyrat
Showing Friends 1 to 10 of 13
Page 1 of 2 12 LastLast
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check