StainLess Steel MediaWidenersRotoMetals2Repackbox
Lee PrecisionTitan ReloadingGraf & SonsInline Fabrication
MidSouth Shooters Supply
Tab Content
  • tigweldit's Avatar
    10-19-2018, 07:40 PM
    I am very happy with Wiltons. I have four of them in various sizes. All made in U.S.A. NEVER use a hammer or "cheater bar" to tighten up the jaws on any vise. That is the best way to do permanent damage to a vise.
    33 replies | 899 view(s)
  • tigweldit's Avatar
    10-13-2018, 12:36 AM
    tigweldit replied to a thread Taurus raging bull in Cast Boolits
    I've had my 454 Raging Bull for better than 15 years. Have put over 1,000 rounds of mainly full house j-word rounds through it. No problems. Good accuracy. Just got a Lee 300 grain mold. Going to powder coated gas checked boolets from here on. I...
    11 replies | 593 view(s)
No More Results
About tigweldit

Basic Information

About tigweldit
N.E. Wisconsin
Retired pipefitter/welder


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Yesterday 11:23 PM
Join Date
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check