RotoMetals2StainLess Steel MediaGraf & SonsInline Fabrication
Titan ReloadingRepackboxWidenersLee Precision
MidSouth Shooters Supply
Tab Content
  • fa38's Avatar
    10-25-2018, 09:05 AM
    JonB in Glencoe-If the "I" portion of the die isn't left in a recess position in the die body, you need to do whatever it takes to do so. Next if the boolit is to have a GC applied, it must be seated square before inserting the GC'd boolit into the...
    7 replies | 453 view(s)
  • fa38's Avatar
    10-24-2018, 10:00 AM
    I am having a hard time getting the bullet into the sizing hole on the die in my RCBS lube sizer. I shave the nose with the top punch or get the base of the bullet hung up on the edge of the hole in the die. I have tried putting the bullet...
    7 replies | 453 view(s)
No More Results
About fa38

Basic Information

About fa38
Location:
Wisconsin

Signature


Member of: ASSRA, Cast Bullet Assoc., Van Dyne Sportsmen's club, NRA, IHMSA

Interests: Shooting single shot rifles and old military rifles with cast bullets.

Statistics


Total Posts
Total Posts
142
Posts Per Day
0.03
General Information
Last Activity
Yesterday 11:07 PM
Join Date
08-09-2007
Referrals
0
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check