Titan ReloadingADvertise hereWidenersRotoMetals2
Inline FabricationMidSouth Shooters SupplyLee PrecisionRepackbox

Tab Content
  • yeahbub's Avatar
    06-23-2020, 12:22 PM
    Screwdriver shafts may work. It might matter whether they were gotten from the dollar bin at the check-out counter. Another source would be a section of coil spring that's straight. You don't mention what diameter you'll need to start with. No...
    13 replies | 435 view(s)
  • yeahbub's Avatar
    06-23-2020, 12:18 PM
    yeahbub replied to a thread Kar 98k in Cast Boolits
    I think you're right. It's just a guess on my part, but it's a good bet that filling the lube grooves to capacity and adding a gas check (for another lube groove) will show much improvement. Lube is a noncompressible fluid and is hydraulically...
    20 replies | 782 view(s)
  • yeahbub's Avatar
    06-19-2020, 12:45 PM
    Yeah, I heard that you dare not venture out without the newest .999 MAGNUM crew served. Those deer are dangerous! A couple years ago, one attacked my car as I was driving down the road! The .30-30 has been known to bounce off of them. Anemic!...
    53 replies | 1937 view(s)
  • yeahbub's Avatar
    06-18-2020, 12:27 PM
    yeahbub replied to a thread Kar 98k in Cast Boolits
    ". . . getting some leading. . .' Could you describe the degree of leading you speak of? A slivery-grey frost removable with solvent and brush? I get this pretty commonly, but it doesn't get any worse over a string of shots. Heavy streaking and...
    20 replies | 782 view(s)
  • yeahbub's Avatar
    06-12-2020, 12:35 PM
    yeahbub replied to a thread Casting for 30/30 in Cast Boolits
    I have tried paper patched and tumble-lubed, paper patched and Teflon-wrapped, and Teflon wrapped bare lead. Both PP types worked very well, so much so that there was nothing to be gained by wrapping the PP'd boolit with Teflon tape also, so I gave...
    21 replies | 1717 view(s)
  • yeahbub's Avatar
    06-08-2020, 12:37 PM
    I have a question about the factory pawl(s); Do they have one which will index the chambers for loading? My second-hand Bisley .44 mag is annoying to load, having to have the chambers carefully held in position, but my Super Blackhawk chambers align...
    6 replies | 425 view(s)
No More Results
About yeahbub

Basic Information

Statistics


Total Posts
Total Posts
583
Posts Per Day
0.12
General Information
Last Activity
Yesterday 01:01 PM
Join Date
08-08-2007
Referrals
0
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check