RotoMetals2StainLess Steel MediaTitan ReloadingGraf & Sons
Lee PrecisionMidSouth Shooters SupplyInline FabricationADvertise here

Tab Content
  • mikeatl's Avatar
    12-27-2017, 10:17 AM
    The metplate is the flat part on the business end of the boolit. It weighs 125 grains, It is angled around the edge of the base , The lube grooves are rounded in the bottom not cut square like a Keith boolit , and I guess the way to describe a semi...
    15 replies | 1108 view(s)
  • mikeatl's Avatar
    12-22-2017, 03:53 PM
    The H&G site describes the 264 as 125g, bevel base , round grease grove , semi wadcutter , small metplate . If this is not right please delete . Mike
    15 replies | 1108 view(s)
  • mikeatl's Avatar
    12-20-2017, 09:09 PM
    Anotherred , go to the link I provided and go to page 8 . About 3/4 way down look for the post by Mozella. He describes the use of the proximity sensor that does away with the speed controller for the feed drive.
    11 replies | 432 view(s)
  • mikeatl's Avatar
    12-20-2017, 07:08 PM
    I have made one like it. There is a thread on about it. The one I made I only used 1 controller and hooked the feed motor on a proximity switch . The motor does not turn until you need another case . The address is...
    11 replies | 432 view(s)
No More Results
About mikeatl

Basic Information

About mikeatl


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Today 08:42 PM
Join Date
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check