Inline FabricationTitan ReloadingRotoMetals2ADvertise here
Lee PrecisionRepackboxWideners

  • SWANEEDB's Avatar
    Today, 01:07 PM
    Military brass going to dg31872.
    6 replies | 286 view(s)
  • georgerkahn's Avatar
    Today, 08:27 AM
    I wish to add that what truly positively amazes me, while not mentioned, is the Internet which no doubt enable it all to happen! From a wonderful seller on the site I purchased a no-longer-made .45 Colt RCBS mould -- click (to buy), click (to pay),...
    11 replies | 438 view(s)
  • georgerkahn's Avatar
    Today, 08:02 AM
    Years back I had a Weaver scope on a .30-30 WCF lever which would also migrate forward. I meticulously cleaned both the 'scope and inside of rings, and reassembled to find exact spot where I wanted everything. I then put a teeny drop of Wite-Out...
    22 replies | 268 view(s)
  • SWANEEDB's Avatar
    Yesterday, 09:07 PM
    None i'm aware of.
    6 replies | 286 view(s)
  • SWANEEDB's Avatar
    Yesterday, 04:56 PM
    Box from the past turned up, 30 carbine brass which i'll never use. 1. 1060 by weight mixed dates of military brass, $127.00, that's around .12 cents per case. ((military brass SOLD)) 2. 590 by weight mixed head stamp commercial brass, $82.00,...
    6 replies | 286 view(s)
  • georgerkahn's Avatar
    02-19-2020, 08:27 PM
    I will be privileged to purchase: Item 1, 44 mag range pickup, mixed HS, some nickel plated. Per my scale a weight of a little over 3.75 pounds so approx 210 pieces. $17 TYD. AND Item 3, fifty (50) pieces of 44 Russian from 44 mag range...
    3 replies | 381 view(s)
  • georgerkahn's Avatar
    02-19-2020, 03:21 PM
    I'm hoping this helps, assuming you have not tried this avenue. To wit, Birchwood Casey offers quite the selection of covers for both ends of many, many scope sizes -- and I hope one (or more) of the size you seek is offered. They have a cover...
    3 replies | 88 view(s)
  • georgerkahn's Avatar
    02-19-2020, 09:04 AM
    I will be privileged to: Take them both for $80 shipped, save $10. georgerkahn PM to follow. Payment edit: OP PM'd me his name/address, and my cheque to him is in U S mail. geo
    2 replies | 163 view(s)
  • georgerkahn's Avatar
    02-18-2020, 03:56 PM
    I had taken Manhattan and similar fat, wet, 'phone books, and shot them at what I reckoned would be my maximum critter range to see what the pellet might do -- e.g., bounce off, travel part way, or -- all the way through the 'phone book. The...
    18 replies | 331 view(s)
  • georgerkahn's Avatar
    02-18-2020, 09:10 AM
    Using same bullet as you, I load IMR3031 to 25 grains; have done this load for years; and, probably will not ever try to "improve" upon it. My .30-30 is a Marlin 336 "beater"... A good read on this bullet is at...
    22 replies | 2107 view(s)
  • georgerkahn's Avatar
    02-17-2020, 09:25 AM
    I salute your wisdom in taking apart mystery cartridges! It sounds as you have the bullet removal challenge licked; for me, a lot is based if I wish to re-use said bullet. You indicated you do not possess a rifle in this calibre, but do you have a...
    25 replies | 626 view(s)
  • georgerkahn's Avatar
    02-16-2020, 02:28 PM
    For what it's worth, my Number 1 concern was ricochet -- primarily the fired bullet bouncing back and hitting me or someone! (I still recall the "you'll get your eye shot out, or shoot someone else's" admonitions from Mom when I went "huntin'" with...
    35 replies | 780 view(s)
  • georgerkahn's Avatar
    02-16-2020, 11:01 AM
    "My" rule of thumb has been to take a sized, lubed, bullet, and drop it into a cylinder. If the bullet falls through by its own weight, or a thump of revolver to my other palm -- then it's too skinny. A fatter bullet is needed! At the other...
    33 replies | 879 view(s)
  • georgerkahn's Avatar
    02-15-2020, 04:42 PM
    John -- alamogunr -- you clearly are in the right frame re these firearms! One thought I maintain is that not only are they not being made anymore, but the most recent ones are more than a half-century old! Possibly not a good thing to write on a...
    30 replies | 833 view(s)
  • georgerkahn's Avatar
    02-15-2020, 04:17 PM
    I will be privileged to purchase: 468pcs of Starline 44 mag 1X fired along with 50 WW and 40 PMC 2X fired for sale. These will ship via USPS medium flat rate box, priced at $80 shipped PM to follow. Thanks again! georgerkahn geo Payment...
    1 replies | 229 view(s)
  • georgerkahn's Avatar
    02-15-2020, 07:36 AM
    I'll mirror what Alstep and others have posted, perhaps adding/reinforcing this one VERY important fact: To wit, you really can do damage to yourself, and most notably (op rod) your M1s, if you do not either use factory, or reload, loads...
    30 replies | 833 view(s)
  • georgerkahn's Avatar
    02-14-2020, 11:43 AM
    Sadly (for the firearms) I was present for two slam-fires. That in many military-style firearms the metal piece which hits the primer to break its anvil and ignite the powder is free floating is a major factor. Even in the course of another...
    17 replies | 366 view(s)
  • georgerkahn's Avatar
    02-14-2020, 08:36 AM
    Thanks for headsup/post! I've kind of wanted one of these (the HP358439) for quite a while. Guru Glenn Fryxell wrote a piece about it at http://www.lasc.us/Fryxell38KeithHP358439.htm; Western Bullets is selling these, made & lubed for roughly 16...
    3 replies | 256 view(s)
  • georgerkahn's Avatar
    02-13-2020, 11:05 AM
    I once dated an Officer's model... (until I found out she was that ;) ) Bion, too, she was into horses -- rode English -- but had no colts... (Rule # 327: Never date anyone who's SO has power over you) geo
    7 replies | 325 view(s)
More Activity
About georgerkahn

Basic Information

About georgerkahn
Biography:
Happily married w/ both sons grownup and moved away; wife is retired RN. God knows how many years either of us will have... but trying to live the best of whatever there will be.
Location:
South of the (Canada) border
Interests:
Play piano, fish, target shoot, woodworking, chainsaws
Occupation:
happily retired after 42 years at one job!

Statistics


Total Posts
Total Posts
1,568
Posts Per Day
0.67
General Information
Last Activity
Today 09:02 PM
Join Date
09-21-2013
Referrals
0

2 Friends

  1. SWANEEDB SWANEEDB is offline

    Boolit Master

    SWANEEDB
  2. Wasalmonslayer Wasalmonslayer is offline

    I'm A Honcho!

    Wasalmonslayer
Showing Friends 1 to 2 of 2
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check