Graf & SonsADvertise hereStainLess Steel MediaMidSouth Shooters Supply
Titan ReloadingInline FabricationLee PrecisionRotoMetals2

Tab Content
  • swheeler's Avatar
    Today, 09:18 PM
    I hope you win!;-)
    17 replies | 151 view(s)
  • HATCH's Avatar
    Today, 09:13 PM
    HATCH replied to a thread New Vulcan. 25 in AirGuns
    I am sure it is a nice air rifle for sure but I can't personally justify spending that kind of money. I will have to say, I thought about getting one of those .357 cal air rifles that use standard projectiles.
    8 replies | 124 view(s)
  • HATCH's Avatar
    Today, 09:06 PM
    I would just run the autotune feature and let it set the settings
    4 replies | 70 view(s)
  • 9.3X62AL's Avatar
    Today, 09:00 PM
    The powder I used during the above-described chamber-ringing incident was Alliant 2400/10.0 grains. I'll be back in a bit, I need to go buy that lottery ticket now.
    17 replies | 151 view(s)
  • swheeler's Avatar
    Today, 08:51 PM
    I have never ringed a chamber using dacron, and have used a bit of it, but use it as described above by Larry. I do remember reading at least one article in the 1980's about several 308 chambers being ringed in one season of cast bullet competition,...
    17 replies | 151 view(s)
  • Down South's Avatar
    Today, 08:50 PM
    Down South replied to a thread Kitchen Counter Tops in Our Town
    I went with Granite the last two times "Two Houses". My last house, the one that I live in now, I have Granite counter tops and an island out of a slab of 1-1/4" Granite. It ain't cheap but it is permanent.
    25 replies | 460 view(s)
  • HATCH's Avatar
    Today, 08:50 PM
    HATCH replied to a thread New Vulcan. 25 in AirGuns
    correct me if I am wrong, but isn't that airgun around $1500?
    8 replies | 124 view(s)
  • Down South's Avatar
    Today, 08:12 PM
    I have three house dogs and they are all Liberal Democrats. They have free housing, free utilities, free health care, free food, free stuff and they don't have to work. All they do is lay around and complain "whine", usually wanting more free stuff...
    1 replies | 35 view(s)
  • Down South's Avatar
    Today, 07:53 PM
    I reshape all of my hats when needed and I have a number of them. A steamer and a bit of patience is all you need. If you don't have a steamer a pot of boiling water will work. Hold the hat over the pot to soak up the steam. Work on one area at a...
    10 replies | 348 view(s)
  • 9.3X62AL's Avatar
    Today, 07:33 PM
    I ruined a nice rifle chamber in a nice Win 94 a few years ago via use of dacron wadding left lofted over small-bulk powder charges--caliber was 25/35 WCF, rifle was a flatband example (insert serial cuss words {HERE}). I salvaged the matter by...
    17 replies | 151 view(s)
  • dale2242's Avatar
    Today, 06:48 PM
    NSB, Thanks for your advice of looking it up. I`m sure you have no idea how much time I spent researching this subject. If this subject is of no interest to you why bother reading this thread or answering it? Some here may want to discuss it...
    17 replies | 151 view(s)
  • 9.3X62AL's Avatar
    Today, 06:10 PM
    Well, Fiocchi brass has been good stuff for me in all respects. $20/1K is a killer price, too. If shipping doesn't bite ya too hard, it might be a good gamble.
    17 replies | 283 view(s)
  • HATCH's Avatar
    Today, 05:11 PM
    Finally got in some of the correct probes. I can offer the next purchaser the option of having a connector on the TC so you can use the PID for another device. No charge Sent from my iPhone using Tapatalk
    34 replies | 5466 view(s)
  • HATCH's Avatar
    Today, 05:09 PM
    Bump to the top. I am making the limit switch brackets now so I will be including them at no charge. Sent from my iPhone using Tapatalk
    14 replies | 1588 view(s)
  • Wayne Smith's Avatar
    Today, 04:50 PM
    I have my grandmother's 5 shot H&R 32S&W. I bought a box of buckshot, size them to fit, and load over 1gr BE. It's a fun little gun, can almost hide it in my hand. I load them on my TrueLine Jr., too.
    9 replies | 167 view(s)
  • John Ross's Avatar
    Today, 04:37 PM
    Hold up the bullet next to a primed case and see how far the shank goes in when loaded. Fill the case to this level with 4227 and weigh the charge. That's your load. It will go about 1100-1300 FPS depending on barrel length and run about 26,000...
    2 replies | 48 view(s)
  • Wayne Smith's Avatar
    Today, 04:15 PM
    Post #7 bought it for $500, the thief! Discount for driving on the ice, maybe? Do I sound jealous? Yeah.
    13 replies | 321 view(s)
  • dale2242's Avatar
    Today, 03:58 PM
    As I read about dacron fillers I am seeing the general consensus is to leave the dacron fluffy and not push it down against the powder as that will make a wad and cause a ring in the chamber as the powder gases will compress the air between the...
    17 replies | 151 view(s)
  • Thumbcocker's Avatar
    Today, 02:39 PM
    I have seen exactly 2 #3's in .30-40 for sale and bought them both. Boolit shooting machines.
    14 replies | 261 view(s)
More Activity
About 45nut

Basic Information

Date of Birth
April 16
About 45nut
Biography:
Albert Camus
"The welfare of the people in particular has always been the alibi of tyrants, and it provides the further advantage of giving the servants of tyranny a good conscience "
Location:
Orygun

Signature


Boolits= as God laid it into the soil,,grand old Galena,the Silver Stream graciously hand poured into molds for our consumption.

Bullets= Machine made utilizing Full Length Gas Checks as to provide projectiles for the masses.

http://www.cafepress.com/castboolits

castboolits@gmail.com

Statistics


Total Posts
Total Posts
4,761
Posts Per Day
1.01
Albums
Total Albums
1
Total Photos
5
General Information
Join Date
03-14-2005
Referrals
51

237 Friends

  1. 380Lady 380Lady is offline

    Boolit Mold

    380Lady
  2. 40sandwfan 40sandwfan is offline

    Boolit Buddy

    • Send a message via MSN to 40sandwfan
    • Send a message via Yahoo to 40sandwfan
    40sandwfan
  3. 50-170-700 sharps 50-170-700 sharps is offline

    Boolit Bub

    50-170-700 sharps
  4. 82nd airborne 82nd airborne is offline

    Boolit Master

    82nd airborne
  5. 9.3X62AL 9.3X62AL is online now

    Boolit Master

    9.3X62AL
  6. acemedic13 acemedic13 is offline

    Boolit Master

    acemedic13
  7. Ajax Ajax is offline

    Banned

    Ajax
  8. Alchemist Alchemist is offline

    Boolit Master

    Alchemist
  9. alfloyd alfloyd is offline

    Boolit Master

    alfloyd
  10. ammohead ammohead is offline

    Boolit Master

    ammohead
Showing Friends 1 to 10 of 237
Page 1 of 24 1234567891011 ... LastLast
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check