RotoMetals2WidenersLee PrecisionGraf & Sons
MidSouth Shooters SupplyInline FabricationTitan ReloadingStainLess Steel Media

Tab Content
  • clodhopper's Avatar
    09-14-2018, 12:58 AM
    clodhopper replied to a thread Swage die reamer in Swaging
    Nice cutter Bill, I have this set of collet blocks, but have not used it yet making reamers. https://www.ebay.com/i/112194207638?chn=ps And a set of 5C collets
    19 replies | 591 view(s)
  • clodhopper's Avatar
    09-06-2018, 09:41 AM
    clodhopper replied to a thread Swage die reamer in Swaging
    I have been moving to the same goal. It seems like the numbers are fuzzy. Starting with O-1 tool steel, you turn to say .308. With heat treating that diameter may change, pretty much have to try, and see what happens. So far I have built a radius...
    19 replies | 591 view(s)
  • clodhopper's Avatar
    09-02-2018, 07:25 PM
    A forum member PMed for more info. From sandbags it will shoot 1 1/2 -2 1/2 inches at 50 yards. with home made 185 grain jacketed bullets formed from 9mm cases. The bullets are formed in a .223 rem resizing die. then sized back down to .358 in a...
    248 replies | 82915 view(s)
  • clodhopper's Avatar
    09-02-2018, 08:41 AM
    Followed this thread for 8 years now. Voted yes today, bought a 77-357 several years ago. Yep it was pricey, sucks as a bench gun. When .22 long rifle was hard to get, this was my solution. A wonderful rifle for walking around making quick...
    248 replies | 82915 view(s)
  • clodhopper's Avatar
    08-31-2018, 09:17 AM
    These molds will be a great asset to the air gun industry. Suddenly a 30 cal springer could be in my future. I would pay handsomely for a 30 cal rifle incorporating mechanical recoil cancellation. Right now, a 22 caliber hunter mold would make...
    46 replies | 1393 view(s)
  • clodhopper's Avatar
    08-25-2018, 08:50 AM
    Most bullet sizing dies have an ejector pin on the end opposite where the bullet would go in. When you push a bullet into a die with enough force to change it's shape, it takes some push to overcome friction and vacuum to get the bullet back out of...
    3 replies | 346 view(s)
No More Results
About marteeson

Basic Information

Statistics


Total Posts
Total Posts
0
Posts Per Day
0
General Information
Last Activity
01-12-2013 08:44 PM
Join Date
11-17-2012
Referrals
0

1 Friend

  1. clodhopper clodhopper is online now

    Boolit Master

    clodhopper
Showing Friends 1 to 1 of 1
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check