Graf & SonsStainLess Steel MediaWisconsin TriggerLee Precision
MidSouth Shooters SupplyRotoMetals2Inline FabricationTitan Reloading

Tab Content
  • Rich22's Avatar
    03-21-2017, 07:46 PM
    Finished weighing some of the lead I have ready for sale. Starting with the SOWW, did not get much from this as I did not get many stick ons. Range lead and COWW coming soon. Everything here was skimmed of all impurities, fluxed 3 times with...
    0 replies | 142 view(s)
  • Rich22's Avatar
    03-05-2017, 02:57 PM
    Rich22 replied to a thread ThermoCouple/PID Issue in Cast Boolits
    Never knew this would become a science thread when I started it. I'm at about 85 feet so 212 should be very very close
    13 replies | 298 view(s)
  • Rich22's Avatar
    03-04-2017, 04:47 PM
    Rich22 replied to a thread ThermoCouple/PID Issue in Cast Boolits
    Just remembered I have one in my oven I can grab to at least check out the thesis of which is bad, far too large to use in my pot but it will tell me what is up most likely. Shall report back later. Appreciate the help guys
    13 replies | 298 view(s)
  • Rich22's Avatar
    03-04-2017, 03:13 PM
    Here is a weird one Everything was fine after last casting session with my homemade (with much help from OB) PID. Went out last time and it seemed off a bit but I increased temp and it worked. Brought it in to check out and at normal room temp...
    13 replies | 298 view(s)
No More Results
About Rich22

Basic Information

About Rich22
Orlando Fl


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Today 10:52 AM
Join Date
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check