Titan ReloadingRotoMetals2StainLess Steel MediaADvertise here
Inline FabricationLee PrecisionMidSouth Shooters SupplyGraf & Sons

Tab Content
  • quack1's Avatar
    06-05-2018, 07:32 AM
    Yeah, 1.5" is probably too much. You can always file the notch in the rear sight deeper, or get a taller front sight. If you don't want to alter the original rear sight by filing, maybe make a replacement for the center piece and keep filing the...
    24 replies | 1288 view(s)
  • quack1's Avatar
    06-03-2018, 09:46 PM
    The center part, with the notch, should slide up and down. To fine-adjust the sight in addition to the coarser steps on the elevator. The screw secures it.
    24 replies | 1288 view(s)
  • quack1's Avatar
    05-23-2018, 08:11 AM
    And you didn't even have to go to tire stores, any gas station that had a bay had one of those cone shaped, with the bubble level on top, wheel balancers and had a an overflowing bucket or collapsed cardboard box full of used weights in the corner. ...
    19 replies | 1170 view(s)
No More Results
About quack1

Basic Information

Date of Birth
July 25, 1952 (65)
About quack1
Location:
Butler, Pennsylvania
Interests:
hunting, shooting
Occupation:
retired

Statistics


Total Posts
Total Posts
624
Posts Per Day
0.13
General Information
Last Activity
06-05-2018 07:33 AM
Join Date
03-25-2005
Referrals
0
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check