Inline FabricationMidSouth Shooters SupplyGraf & SonsTitan Reloading
StainLess Steel MediaLee PrecisionRotoMetals2Wideners
Repackbox
  • 429421Cowboy's Avatar
    10-19-2018, 11:47 AM
    429421Cowboy replied to a thread Bullets in a fire in Our Town
    I have seen cases after a fire, and they generally are split open and jagged looking, with the bullet often still in place (maybe it has to do if the bullet was crimped or not?). I'd say that there is a small degree of eye danger, but doubt they'd...
    24 replies | 659 view(s)
  • 429421Cowboy's Avatar
    10-19-2018, 10:49 AM
    Very cool! Good luck to you, I hope you get it done with the Marlin!
    20 replies | 393 view(s)
  • 429421Cowboy's Avatar
    10-17-2018, 12:38 PM
    I have owned this book for quite awhile, and enjoy it for reading about how different things are now than they were then. An interesting side note being that I grew up not far from Lewistown, and have an uncle that gave me a good bit of his...
    22 replies | 3312 view(s)
  • 429421Cowboy's Avatar
    10-17-2018, 12:22 PM
    I believe that is from the old Winchester Bi-centinnial commemorative ammo they sold, boxes go for pretty decent money now.
    15 replies | 999 view(s)
  • 429421Cowboy's Avatar
    10-15-2018, 12:06 PM
    I guess my comparison for the 9mm would be the .357 Mag. We all know that .357 is about the starting level for a "real" bear gun, and with the Buffalo Bore offerings (+P+) the 9 is elevated into .357 territory. I do know two gentlemen that have...
    95 replies | 2820 view(s)
  • 429421Cowboy's Avatar
    10-11-2018, 05:44 PM
    429421Cowboy replied to a thread Sheep shears in Our Town
    Nifty deals, I have a couple laying around and am glad I dont have to use them now! Just read an article in Backwoodsman about a guy that made a cabbage knife out of one since they are pretty good steel.
    9 replies | 368 view(s)
  • swheeler's Avatar
    10-11-2018, 04:36 PM
    From 4 to 50 ft. Great video by the way! I do like your speed loader ;-)
    37 replies | 1035 view(s)
  • 429421Cowboy's Avatar
    10-11-2018, 02:52 PM
    The best! Hoping to make it to NCBS and meet some folks this spring!
    12 replies | 519 view(s)
  • 429421Cowboy's Avatar
    10-10-2018, 07:09 PM
    Also... can't see from your photos but the bolt on a trainer doesn't have front locking lugs, just two in the rear. You can't fit a rifle bolt into a trainer but you can fit a trainer into a rifle (BAD IDEA). The trainers often had a set screw ...
    36 replies | 1197 view(s)
  • 429421Cowboy's Avatar
    10-10-2018, 06:53 PM
    I'm with Ken and Texas on this one, a whole isn't adding up on this rifle. The barrel shouldn't do that and it certainly should have the serial number on the left side, with a series mark in front of that and the arsenal mark on the other end as...
    36 replies | 1197 view(s)
  • 429421Cowboy's Avatar
    10-10-2018, 06:43 PM
    Thank you!
    12 replies | 519 view(s)
  • 429421Cowboy's Avatar
    10-10-2018, 06:43 PM
    Thank you guys, I ordered a set from optics planet. A special thanks to Texas by God for the generous offer as well!
    12 replies | 519 view(s)
  • 429421Cowboy's Avatar
    10-09-2018, 03:47 PM
    What curator said. If you get it nice and shiny clean (easy enough with the chromed bores) you can look down it and see the rifling, but it'll look more like swirls in the light than real sharp cut rifling. Check the crown on it, may have to touch...
    36 replies | 1197 view(s)
  • swheeler's Avatar
    10-09-2018, 12:18 PM
    swheeler replied to a thread Breaking & Entering in Our Town
    If you have multiples "same keyed" is nice, pockets are full of enough stuff! ;-)
    24 replies | 1084 view(s)
  • swheeler's Avatar
    10-09-2018, 09:44 AM
    swheeler replied to a thread Breaking & Entering in Our Town
    Try this.......https://homak.com/customer-service/
    24 replies | 1084 view(s)
  • 429421Cowboy's Avatar
    10-08-2018, 07:53 PM
    Restoring a little faith in humanity after an attempted break-in and stolen licence plate this week! Thank you very much, you are a gentleman and a scholar. I will post a good PIF for someone in your honor sir!
    12 replies | 519 view(s)
  • 429421Cowboy's Avatar
    10-08-2018, 01:07 PM
    I was not aware the level of difficulty involved in finding non-detachable sling swivels! I am working on a little rifle project, that I'll detail here at some point, but it is a sporterized mil-surp, cut down to carbine length with a dandy little...
    12 replies | 519 view(s)
  • 429421Cowboy's Avatar
    10-06-2018, 08:15 AM
    I was looking through old posts about NCBS yesterday and decided that if there is any way in heck or high river I can make it this year I am going to try and be there this year! I spend the majority of my time in Nevada around the Winnemucca area,...
    17 replies | 624 view(s)
  • 429421Cowboy's Avatar
    10-04-2018, 11:48 PM
    429421Cowboy replied to a thread Whole Home Generator in Our Town
    We also have a Generac unit at the ranch that is hooked into the natural gas line. It is likely close to 15 years old, and has given good service with only regular maintenance. We got the 22kw unit to have enough power to keep the freezers full of...
    68 replies | 2235 view(s)
  • 429421Cowboy's Avatar
    10-04-2018, 10:53 PM
    Thank you all for the welcome back, I have truly missed every one of you and it is great to see familiar faces. It has been a rough and tumble few years, but we have hung tight. Katelyn is in a rough place with her health, but with God's grace we're...
    17 replies | 624 view(s)
  • 429421Cowboy's Avatar
    10-04-2018, 10:28 AM
    I'll have to dig up a picture and post it here but I found a .50 BMG casing laying in the desert near Rachel, Nevada just outside the current day bombing range at Nellis AFB that has the S L 4 headstamp and you can still see the marks where it was...
    28 replies | 1036 view(s)
  • 429421Cowboy's Avatar
    10-03-2018, 11:46 AM
    I am back guys! I've been missing you guys for a long while and finally decided I needed to come back to the site that has always given me so much. I left quietly and quickly a few years back because of a horrible experience on a different forum...
    17 replies | 624 view(s)
  • swheeler's Avatar
    10-02-2018, 09:52 AM
    swheeler replied to a thread Photobucket Caved in Our Town
    I said my good byes a year ago, will never darken their doorway again.
    26 replies | 899 view(s)
  • swheeler's Avatar
    09-30-2018, 01:14 PM
    The wife's vehicle and mine do not have gas caps or locking gas doors, they have built in anti-siphon features but without a locking gas door something could be poured into the tank.
    123 replies | 4351 view(s)
No More Results
About 429421Cowboy

Basic Information

About 429421Cowboy
Location:
Montana
Occupation:
I work for three different brands and also run my own herd.

Signature


Raisin' Black Angus cows, outta gas, outta money, outta tags, low on boolits, but full 'a hope on the Rocky Mountain Eastern Slope!
Why does a man with a 7mag never panic buy? Because a man with a 7mag has no need to panic!

"If you ain't shootin', you should be reloadin' if you ain't reloadin' you should be movin', if you ain't movin', somebody's gonna come by and cut your head off and put it on a stick!" Words to fight by, from Clint Smith

Statistics


Total Posts
Total Posts
1,098
Posts Per Day
0.40
General Information
Last Activity
10-19-2018 11:02 PM
Join Date
04-12-2011
Referrals
0

1 Friend

  1. swheeler swheeler is offline

    Boolit Master

    swheeler
Showing Friends 1 to 1 of 1
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check