Inline FabricationADvertise hereRotoMetals2StainLess Steel Media
Graf & SonsTitan ReloadingLee Precision

  • BRUCE MOULDS's Avatar
    11-12-2017, 04:05 AM
    a good set of rings sized to suit the aiming mark. plenty of white around the aiming mark is the goal. the aiming mark should appear about 1/3 of the hole size. this allows the brain to subconsciosly centre things up. keep safe, bruce.
    9 replies | 283 view(s)
  • BRUCE MOULDS's Avatar
    11-11-2017, 07:33 PM
    randy, by all reports, hoke is a very good sight. as mentioned, use of such sights requires an understanding of and familiarity with using vernier adjustments and an understanding of minutes of angle. with these things in hand, and the knowledge...
    9 replies | 524 view(s)
  • BRUCE MOULDS's Avatar
    11-05-2017, 12:06 AM
    annealing, or more correctly partial annealing, of brass cases is not rocket science. all you have to know is that you need to get the necks up to 700 - 750 degrees f. and you have to keep the bottom 1/2 to 2/3 of the case less than 400 degrees f....
    18 replies | 873 view(s)
No More Results
About BRUCE MOULDS

Basic Information

About BRUCE MOULDS
Location:
australia
Interests:
long range shooting

Statistics


Total Posts
Total Posts
176
Posts Per Day
0.07
General Information
Last Activity
Yesterday 06:14 PM
Join Date
11-11-2010
Referrals
0

1 Friend

  1. Red River Rick Red River Rick is offline

    Master Tool & Die Maker

    Red River Rick
Showing Friends 1 to 1 of 1
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check