Inline FabricationLee PrecisionStainLess Steel MediaTitan Reloading
RepackboxRotoMetals2WidenersMidSouth Shooters Supply
Graf & Sons
Tab Content
  • M-Tecs's Avatar
    Today, 03:19 AM
    M-Tecs replied to a thread 6.5 Creedmore - NOT in Factory Rifles
    Yes it will feed the very long bullets used by the long range competitors out of a 308 length mag. With the .260 using the same long bullets the mag runs out of space.
    68 replies | 3227 view(s)
  • No_1's Avatar
    10-12-2018, 05:02 PM
    6 molds for $75 shipped? I'll take them! PM sent.
    1 replies | 189 view(s)
  • No_1's Avatar
    10-10-2018, 07:51 AM
    No_1 replied to a thread A thanks to all. in Our Town
    Glad to be of help! Take care, Robert
    7 replies | 344 view(s)
  • M-Tecs's Avatar
    10-09-2018, 11:52 AM
    Sometimes they fit but normally they require fitting . http://www.ktgunsmith.com/45acp_cyl.htm
    15 replies | 671 view(s)
  • M-Tecs's Avatar
    10-09-2018, 11:49 AM
    In the early 1900's it was very common for competition shooting. It greatly reduces fouling. Most BP competitions do not allow it today. http://castboolits.gunloads.com/showthread.php?137201-Black-powder-duplex-loads
    21 replies | 685 view(s)
  • No_1's Avatar
    10-08-2018, 05:25 PM
    No, we are here and no we aren’t ignoring you. Your request to have your S&S privileges restored is being reviewed however it is pretty hard to get past the super sarcastic message you sent to the moderator who issued the infraction that pissed you...
    1 replies | 279 view(s)
  • No_1's Avatar
    10-08-2018, 11:30 AM
    Caution is the word. Be weary as Ballisticast and their spinoffs have had a couple false starts (with loss to mold & equipment investors) since the original owner retired. Take care, Robert
    1 replies | 141 view(s)
  • M-Tecs's Avatar
    10-04-2018, 06:21 PM
    I will take the Lyman 4 Cavity Mold 357446 .358" 162gr SWC with nutcracker handles $65 Shipped USPS Priority mail medium flat rate box using PayPal. PM sent
    18 replies | 2120 view(s)
  • M-Tecs's Avatar
    09-29-2018, 11:47 PM
    No disagreement. I love the.17 Mach 2. My favorite is a Magnum Research semi-auto with a Kidd two stage trigger, I also have the .17 Mach 2 in CZ's, Sako Quads and Contenders. That doesn't change the fact that the cartridge is almost dead. ...
    11 replies | 348 view(s)
  • M-Tecs's Avatar
    09-29-2018, 12:44 PM
    That is one of the primary reasons the cartridge is on life support. Dirty chambers in a shouldered rimfire in semi-auto don't mix so chamber dimension's between manufactures vary greatly. Between the case splits and slam fires ammo manufactures...
    11 replies | 348 view(s)
  • M-Tecs's Avatar
    09-29-2018, 04:59 AM
    Shot some prairie dogs and a couple of skunks with mine. It has been very effective on them.
    11 replies | 348 view(s)
  • M-Tecs's Avatar
    09-28-2018, 09:25 PM
    Like most long range rifle competitors I mostly load on a progressive. We all have no problem holding 1/2 MOA out to a 1,000 yards with a progressive. To produce extremely accurate ammo the same steps have to be followed. Press type makes very...
    61 replies | 1699 view(s)
  • No_1's Avatar
    09-27-2018, 11:58 AM
    Creating additional screen names is against the rules. If you are having issues logging in please utilize the “Contact Us” form for resolution.
    1 replies | 115 view(s)
  • M-Tecs's Avatar
    09-26-2018, 09:11 PM
    Started reloading in at 9 or 10 years old for a re-enactment club. Loading about 50,000 rounds for them on a single station press. Reloading was never fun until I purchased a 1050.
    61 replies | 1699 view(s)
  • M-Tecs's Avatar
    09-21-2018, 10:50 PM
    I have the same question. In the .556 I don't recommend a carbine length gas system. On my match rifles I extend the rifle length gas system 2". I have zero experience with the 458 SOCOM but everything I have read states the carbine length gas...
    10 replies | 368 view(s)
  • M-Tecs's Avatar
    09-21-2018, 09:11 PM
    That would be my point. Consumers rejected lower velocity of the 17 HM2. A low velocity 17 HMR load would fair no better.
    35 replies | 1287 view(s)
  • M-Tecs's Avatar
    09-19-2018, 11:29 PM
    They do it's called the 17 Mach 2 but it didn't sell well and the gun manufactures made the chambers too loose in the semi-auto's so neck and case splits are fairly common. I have several and really like them but I purchased 8K of ammo at a...
    35 replies | 1287 view(s)
  • No_1's Avatar
    09-18-2018, 04:44 AM
    RIP Grumpa. You will be missed.
    65 replies | 2424 view(s)
  • M-Tecs's Avatar
    09-18-2018, 12:44 AM
    https://www.americanrifleman.org/articles/2018/9/17/former-ruger-ceo-william-b-ruger-jr-passes-away/ Sturm, Ruger & Co. is mourning the death of William B. Ruger Jr., former chairman of the board and chief executive officer of Ruger. The...
    2 replies | 124 view(s)
  • M-Tecs's Avatar
    09-15-2018, 08:56 PM
    That could be possible.
    53 replies | 1703 view(s)
  • M-Tecs's Avatar
    09-15-2018, 02:25 PM
    Awhile back I was doing a lot of selling and trading at gun shows. Later I was looking for something else I a discovered a S&W 629 that I have no idea when or how I came to own it.
    53 replies | 1703 view(s)
  • M-Tecs's Avatar
    09-14-2018, 10:22 PM
    M-Tecs replied to a thread Are you "particular"? in Cast Boolits
    It depends on the intended usage of the ammo and guns. For my cowboy action it being safe and reliable is the only real requirement. On my 1,000 yard match rifles I do what to know and control every deal as precisely as humanly possible. On the...
    58 replies | 1503 view(s)
More Activity
About Bullshop

Basic Information

About Bullshop
Location:
Montana
Interests:
Shooting...boolits
Occupation:
Bullet Man

Statistics


Total Posts
Total Posts
6,172
Posts Per Day
1.25
General Information
Last Activity
12-03-2015 03:32 PM
Join Date
03-23-2005
Referrals
5
Home Page
http://bullshop.weebly.com

14 Friends

  1. 45nut 45nut is offline

    Cast Boolits Founder/B.O.B.

    45nut
  2. Arctic Blues Arctic Blues is offline

    Boolit Bub

    Arctic Blues
  3. Bob Krack Bob Krack is offline

    Boolit Master at Heavens Range

    Bob Krack
  4. Bullshop junior x2 Bullshop junior x2 is offline

    Boolit Mold

    Bullshop junior x2
  5. Carolina Cast Bullets Carolina Cast Bullets is offline

    Boolit Buddy

    Carolina Cast Bullets
  6. Etienne Brule Etienne Brule is online now

    Boolit Man

    Etienne Brule
  7. Ithaca1911 Ithaca1911 is offline

    Boolit Bub

    Ithaca1911
  8. M-Tecs M-Tecs is offline

    Boolit Master

    M-Tecs
  9. masscaster masscaster is offline

    Boolit Buddy

    masscaster
  10. No_1 No_1 is offline

    Cast Boolits Owner

    No_1
Showing Friends 1 to 10 of 14
Page 1 of 2 12 LastLast
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check