Graf & SonsInline FabricationMidSouth Shooters SupplyStainLess Steel Media
Titan ReloadingRotoMetals2Lee PrecisionADvertise here

Tab Content
  • Harter66's Avatar
    07-18-2018, 08:17 PM
    What I got for cheap . After some 0000 steel wool and about 6 hr in evaporust. A little cold blue wiped on and wiped down in Hoppes .
    10 replies | 328 view(s)
  • Harter66's Avatar
    07-12-2018, 11:09 PM
    I don't have a Contender . I do have a 1 off rifle in 76.8 . When or if I get back to it I will most likely recut it to 7-30AI Rimless . With that said , the only downside of the 6.8 SPC is the lack of heavy .270 moulds . I do shoot 2 other...
    9 replies | 425 view(s)
  • Harter66's Avatar
    07-12-2018, 07:22 AM
    If I were to do it I might spend the extra buck for money paper . The ideal of course is for all of the evidence that has to or might be dropped or lost at the scene or anywhere near it or connected to you to be so impossibly generic that it could...
    23 replies | 653 view(s)
  • Harter66's Avatar
    07-11-2018, 11:47 AM
    A fellow the other wanted a link to some information I shared ...... Crickets when I suggested old history books , The Lincoln Library of Essential Information , pre 1960 Encyclopedias ,an the National Achieves .
    15 replies | 489 view(s)
  • Harter66's Avatar
    07-11-2018, 12:22 AM
    I guess we just get weary . I try to remind folks that Elmer used 16-1 for what eventually became the 44 mag .
    15 replies | 489 view(s)
  • Harter66's Avatar
    07-09-2018, 08:20 PM
    I the 2 I've had were quite smooth . An 84-86' and a 2013 . Both built on Magnum designated actions . The early one has a barrel band sight and forward magazine support . The later one had a barrel band and dovetails . Both are .444.450+ . ...
    12 replies | 326 view(s)
  • Harter66's Avatar
    07-08-2018, 10:43 PM
    Use a Savage . Choose a cartridge like the 6.8 SPCII . Form 10 cases from 22 NOS . Install a 223 bolt head . Cast 1# of one time alloy with isolated alternative source metal bullets . Use 1 sheet of random source paper . Dry wrap in tight nitrile...
    23 replies | 653 view(s)
  • Harter66's Avatar
    07-08-2018, 05:59 PM
    Many also just left . I hang around a little bit but a lot less than I used to .
    15 replies | 489 view(s)
  • Harter66's Avatar
    07-08-2018, 12:47 PM
    I stumble over an older thread . When that happens I'm reminded by what a great place this has been . It was a place where the old school knowledge of how to pour great boolits every time met the new school stepping stones to do more and more ,...
    15 replies | 489 view(s)
  • Harter66's Avatar
    07-08-2018, 12:20 PM
    I tinkered a lot to find an alloy that would hold the speed and pressures for a couple of small caliber cartridges and still expand without breaking up . 30 cal , 200 gr 197-199 remaining .610 dia , impact speed in powdered dg clay approximately...
    248 replies | 153334 view(s)
  • Harter66's Avatar
    07-08-2018, 11:41 AM
    Harter66 replied to a thread Warning Warning Warning in Our Town
    I had an aquaintance many years ago that lived on a farm kind of out in the boonies . His Misses had bugged him about his stuff on/off but in particular his highschool car that had been tarped on the north side of the barn in the 2 side tractor...
    51 replies | 2018 view(s)
  • Harter66's Avatar
    07-05-2018, 08:29 AM
    Don't forget the Win 9410 . I'd bet that it could be rifled and fed some slow ,low pressure powders . At worst it could be broach rifled through the choke . Cast bullet gun right ? Green Mountain sells a lever gun 45 ACP (this means .451-2 1-16...
    15 replies | 618 view(s)
  • Harter66's Avatar
    06-30-2018, 06:54 PM
    I don't remember the load now . I do know it was proportioned for 45 Colts . That's a 45 cal maxi ball in the 303 Britt brass straightened out for a 410 . It wasn't accurate for beans but the cheap 45/410 single shot pistol had scratches for...
    15 replies | 618 view(s)
  • Harter66's Avatar
    06-30-2018, 06:34 PM
    I had about 3000 when they became unobtainium . I have about 5500 now my grandson is 5 now so it's been 6-7 yrs since I shot any . I did get a 223 and by association a 222 down to really angry 22 mag . They shoot great , are reloadable and ear...
    100 replies | 2199 view(s)
No More Results


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
07-18-2018 08:18 PM
Join Date
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check