MidSouth Shooters SupplyGraf & SonsWidenersRotoMetals2
Lee PrecisionTitan ReloadingStainLess Steel MediaInline Fabrication

  • Multigunner's Avatar
    09-21-2018, 08:03 PM
    I once had a Krag Carbine in wallhanger condition, good overall except for a bore that looked like the surface of the moon. I still regret trading it off since a few years later repro barrels became available. A few years back I was on the verge...
    18 replies | 410 view(s)
  • Multigunner's Avatar
    09-11-2018, 02:16 AM
    I've used "Never Dull" Wadding Polish. Its cotton impregnated with a very fine polish and solvent. On delicate surfaces I don't used the wadding itself, I roll the wadding between my fingers then rub the surface with my finger tips. A very little...
    21 replies | 690 view(s)
  • Multigunner's Avatar
    09-08-2018, 07:21 PM
    They don't use it much anymore its difficult to remove from the screens of PC and Word Processor monitors.
    8 replies | 584 view(s)
  • Multigunner's Avatar
    09-04-2018, 06:10 PM
    Multigunner replied to a thread Rummage sale finds. in AirGuns
    Two of the most satisfying low cost airguns you can get. Long lived designs. Keep them clean and properly lubed, avoid over pumping, and they last just about forever.
    4 replies | 371 view(s)
  • Multigunner's Avatar
    08-31-2018, 05:12 AM
    Multigunner replied to a thread Download 8X56R in Military Rifles
    If the ammo is that old I'd just dump the old powder and reload a starter level charge of fresh modern powder using the powder manufacturers loading recommendations. Some powders can cause excessive pressures with short loads. Even those that...
    15 replies | 633 view(s)
  • Multigunner's Avatar
    08-29-2018, 11:26 PM
    I've noticed that the M1941 outfitted with a scope has shown up in a number of South Korean war movies. A rifle that looks identical to these was seen in the Captain America movie. In that movie it was used as a straightpull, I think the SK prop...
    17 replies | 1115 view(s)
  • Multigunner's Avatar
    08-28-2018, 09:22 PM
    Has anyone rebarreled one of these to .303 British? Would the .303 feed properly in this action?
    15 replies | 492 view(s)
No More Results
About Multigunner

Basic Information


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Yesterday 07:04 PM
Join Date

1 Friend

  1. Bob Krack Bob Krack is offline

    Boolit Master at Heavens Range

    Bob Krack
Showing Friends 1 to 1 of 1
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check