WidenersLee PrecisionTitan ReloadingInline Fabrication
ADvertise hereRepackboxRotoMetals2

Tab Content
ABJ's Activity
About Me
Tab Content
  • ABJ's Avatar
    02-10-2020, 10:40 AM
    I have cast and loaded 3 different 1911/38 special wadcutter guns. One was a Clark SR., one was an AMU conversion and the current one is a 38 super conversion. I dont know who made the current one. Several DEWC cast with coww plus 2 % tin where just...
    13 replies | 911 view(s)
  • ABJ's Avatar
    02-10-2020, 09:33 AM
    Using Dillon dies I crimp to .469 because thats what my guns prefer. As far as powder goes, I use 4.0 grains of bullseye on 185 and 200's. That is a target load. Tony
    21 replies | 1547 view(s)
  • ABJ's Avatar
    01-31-2020, 11:14 AM
    I have tested an off center to a centered sprue in 30-06. Velocity was about 1850 tested at 100 yds. I could not find that it made any difference at all. Just make sure you let the sprue cool enough for a clean cut instead of a tearing that pulls...
    23 replies | 844 view(s)
  • ABJ's Avatar
    01-29-2020, 08:39 AM
    I have worn out two of those molds over the last 10 years or so. I think it is the best wc mold going. I agree with Tazman on only lube the bottom groove. My test reveal the same results he has referenced. With very light loads, 20:1 alloy is...
    12 replies | 437 view(s)
No More Results
About ABJ

Basic Information

About ABJ
Ball Ground, GA
Bullseye and muzzleloading
licensed commercial caster


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
02-14-2020 05:25 PM
Join Date
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check