Graf & SonsRotoMetals2StainLess Steel MediaLee Precision
Inline FabricationTitan ReloadingMidSouth Shooters SupplyWideners

Tab Content
  • RobS's Avatar
    09-03-2018, 09:19 PM
    RobS replied to a thread 10mm boolit mold in Cast Boolits
    Nose length can be an issue as one starts to run heavier weights. I chose 190 grain and designed it to give maximum case capacity with a nose width and length for reliable feeding etc. If a design has too long of a nose with a WFN a person can run...
    16 replies | 457 view(s)
  • RobS's Avatar
    09-03-2018, 12:04 AM
    Powder coating or Hi-Tek coating would be the same as air cooling a bullet if left to air cool. If a person is water dropping then you will yield the typical hardness from water dropping at 400 degrees from the antimony alloy you are using. 400...
    9 replies | 327 view(s)
  • RobS's Avatar
    09-02-2018, 10:07 PM
    RobS replied to a thread 10mm boolit mold in Cast Boolits
    Personally run a 190ish grainer I put together over at accurate molds. I think a weight at 180 to 200g is a good go for a cast boolit.
    16 replies | 457 view(s)
  • RobS's Avatar
    08-31-2018, 09:53 AM
    .380" with a larger meplat is the longest that will reliably cycle in the Rossi and the ogive needs to be a secant or as close to it as possible. A tangent nose profile at .380" and a .320" meplat or wider will likely not cycle. I designed this...
    11 replies | 333 view(s)
  • RobS's Avatar
    08-24-2018, 09:35 AM
    RobS replied to a thread Lee Melting Pot in Casting Equipment
    With all lead out of the pot you can heat it back up and see if you can push a wire of smaller diameter through the spout going from the bottom up. Once could also take the bottom off the bot and then use a drill bit the same diameter or just...
    12 replies | 420 view(s)
No More Results
About Rock

Basic Information

About Rock
Location:
Kalifornia

Statistics


Total Posts
Total Posts
205
Posts Per Day
0.06
General Information
Last Activity
10-03-2017 08:59 PM
Join Date
10-03-2009
Referrals
1

3 Friends

  1. labdwakin labdwakin is offline

    Boolit Man

    labdwakin
  2. RobS RobS is offline

    Boolit Master

    RobS
  3. rugerman1 rugerman1 is offline

    Boolit Master

    rugerman1
Showing Friends 1 to 3 of 3
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check