RepackboxWidenersGraf & SonsInline Fabrication
StainLess Steel MediaRotoMetals2

Tab Content
  • midnight's Avatar
    01-11-2019, 07:51 AM
    The Walnut Hill press uses Walnut Hill dies. Both are available from RCE. RCE also has a reloading adapter available which allows you to use any swaging dies made for use with a standard reloading press. Richard used to and may still have adapters...
    15 replies | 396 view(s)
  • midnight's Avatar
    12-26-2018, 08:15 PM
    Pin gauges are made 0.0002 undersize so you can actually get them to enter the hole you are trying to measure so a punch that is 0.0002 to 0.0003 under the hole dia. should be about right. Bob
    6 replies | 392 view(s)
  • midnight's Avatar
    12-26-2018, 08:07 PM
    I think 20-1 is a bit too hard to squirt out a bleed hole. I tried swaging 20-1 cores with my walnut hill and I won't try it again. I have a die to squirt wire using the Rockchucker and a 300gr soft lead bullet. It could only be done by screwing the...
    3 replies | 391 view(s)
No More Results
About midnight

Basic Information

About midnight
East Troy, WI
Hunt, Fish, Shoot, Archery


Si hostes visibilis, etiam tu


Total Posts
Total Posts
Posts Per Day
General Information
Last Activity
Yesterday 10:41 AM
Join Date
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check