View Full Version : Need OAL of a Lyman 450 push out rod...
imashooter2
10-18-2010, 09:17 PM
Can someone please measure the overall length of their Lyman 450 Push Out Rod? It is item 12 in the parts list or part number 2990306.
Thanks!
geargnasher
10-18-2010, 10:21 PM
Is that the "I" part?
Gear
imashooter2
10-18-2010, 10:34 PM
No, it is the headed rod on the press that hits the "I" part to eject the boolit when you lift the handle...
DuaneH
10-18-2010, 10:39 PM
Mine checks 2.93"
fryboy
10-18-2010, 10:39 PM
one olde lyman 45 reads 2.939
2nd olde lyman 45 reads 2.942
3rd olde yman 45 reads 2.938
and last 4500 reads 2.940
soz dont have a 450 per say [shrugz]
jcwit
10-18-2010, 10:44 PM
Mine mikes at 2.950 overall. Lyman sells the part for the grand sum of $1.00
I should add I rounded my measurements off to the nearest 100ths. Not a critical measurement for this part.
This part is thge same for the model 45 and the 450.
imashooter2
10-18-2010, 10:45 PM
2.93 - 2.94, thanks guys!
imashooter2
10-18-2010, 10:46 PM
Mine mikes at 2.950 overall. Lyman sells the part for the grand sum of $1.00
It's not the money, it's the time. I'm going to be lubing tomorrow. :drinks:
geargnasher
10-18-2010, 11:26 PM
Don't "bump" the boolits so hard!
Gear
jcwit
10-18-2010, 11:33 PM
It's not the money, it's the time. I'm going to be lubing tomorrow. :drinks:
Ya, I hear ya. You can make one from a 1/4 inch bolt and nothing more that a grinder & hacksaw.
I did make one once but I used my lathe, it's not a real precision part.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.