Moly coated boolits.

[PAT303]

I cast up a heap of 8mm boolits and decided to tumble lube some 323366's in moly to see what happens.They came out with a grey dusted appearance so I lubed them with canuba red and fitted checks and loaded them over 16grns of 2400 which is my Turk '98's favourate load and they shot ****.The Turk will put 10 of them inside the 10 ring at 50 but not only did they shoot high but all over in a long string.Anyway it was good fun trying it but I'll go back to my normal load now.Anyone else tried this out?. Pat

[Lee S. Forsberg]

Yes, I've tryed it. The only thing I did differently was to add a cap full of Safeway's 99% Isopropyl to a 9mm casing of Moly and about 200 rounds of cast bullets and tumble for about 30 minutes and let the Isopropyl dry off. I don't know what it does for accuracy but they slide through the sizing die very well.
Lee

[HKnolle]

I've used spray moly for the last twenty years. works just fine.

[XWrench3]

i just mix a table spoon of powdered moly into my L.L.A. and use it for tumble lubing. works fine for what i do.