Bent Ramrod
09-02-2006, 01:58 AM
I found one of these sizer/lubers at a Gun Show and boiled the fossilized grease out of it. It has a screw handle on a reservoir, much like other sizer/lubers, but also a small handle on the base that operates a separate plunger. Sharpe's handloading book mentions this luber, (and a matching loading tool), but there are no instructions on how to use it.
Do you tighten the main screw, push the bullet into the die, press the little lever to lube the bullet and start another bullet in to push the previous one out the bottom?
Has anybody ever seen a specimen of the Meepos Loading Tool? It was a light little two-station job (from the photos I've seen) but handled (I think) standard dies.
These were made and sold by the Meepos Gun Shop in LA back in the glory days when LA wasn't so gun-unfriendly.
Thanks in advance.
Bent
Do you tighten the main screw, push the bullet into the die, press the little lever to lube the bullet and start another bullet in to push the previous one out the bottom?
Has anybody ever seen a specimen of the Meepos Loading Tool? It was a light little two-station job (from the photos I've seen) but handled (I think) standard dies.
These were made and sold by the Meepos Gun Shop in LA back in the glory days when LA wasn't so gun-unfriendly.
Thanks in advance.
Bent