New mold on order

[stubert]

I just ordered a Lyman 44 cal. devestator h.p. I've been using the Lee 310 gc. with great results. Any of you folks have one? Loads for a Ruger SRH?

[HiVelocity]

Friend,

All the Devastator molds are pretty good molds. Here's the problem you're going to experience.

The HP pin has to stay as hot as the mold to work perfectly. I cranked up the pot to 800 degrees to keep things rolling. Depending on your alloy, you should do fine as long as you don't mind using a single cavity mold. 1 at a time sure is slow.

I've progressed to a couple double cavity HP molds, in fact, in 3 calibers. I found that using MiHa's molds (www.mp-molds.com) are superb and produce commercial quality bullets. Read everything you can on this web site; you'll be surprised what you'll learn from the group of guys (no offense ladies) who have done enough T&E to solve most casting problems. Good luck.

BTW, the Devastator bullets do expand.

HV in SC